Automotive Technology II Final Exam
Study Guide Already Passed
In a drum brake assembly, which brake shoe provides the most friction for slowing/stopping a
vehicle? ✔✔Secondary
Technician is retracting caliper piston in order to replace disc brake pads. What step should be
taken before tightening C-Clamp ✔✔Open Bleeder Valve
Technician in reinstalling hub type rotor assembly. What should be checked prior to installing
rotor assembly? ✔✔Wheel Stud Condition
Technician is performing a hydro-boost hydraulic test. With the engine off, the first diagnostic
test you should perform is to pump the brake pedal __ times ✔✔30
Technician is tightening a wheel bearing retaining nut and cannot locate torque specifications.
What torque amount should be used? ✔✔18-20
There are two types of valves used on vehicles with front disc brakes and rear drum brakes. They
are the metering valve and the: ✔✔Proportioning Valve
, Before beginning a repair job, review the procedure in a: ✔✔Service Manual
Floating and sliding type disc brakes need a thin film of hi-temperature grease on the: ✔✔Slides
What can be used to secure brake caliper while rotor is being serviced? ✔✔Wire Hanger
What type wheel bearing is generally replaced as a unit? ✔✔Straight Roller Bearing
What components should be checked during a wheel bearing inspection? ✔✔Race and Rollers
What wheel bearing condition could be the result of lubricant failure? ✔✔Galling
When hand packing a wheel bearing, begin with a small amount of grease in: ✔✔Palm of Hand
What procedure should be followed when installing wheel bearing lock nut? ✔✔Torque to
Specifics
Study Guide Already Passed
In a drum brake assembly, which brake shoe provides the most friction for slowing/stopping a
vehicle? ✔✔Secondary
Technician is retracting caliper piston in order to replace disc brake pads. What step should be
taken before tightening C-Clamp ✔✔Open Bleeder Valve
Technician in reinstalling hub type rotor assembly. What should be checked prior to installing
rotor assembly? ✔✔Wheel Stud Condition
Technician is performing a hydro-boost hydraulic test. With the engine off, the first diagnostic
test you should perform is to pump the brake pedal __ times ✔✔30
Technician is tightening a wheel bearing retaining nut and cannot locate torque specifications.
What torque amount should be used? ✔✔18-20
There are two types of valves used on vehicles with front disc brakes and rear drum brakes. They
are the metering valve and the: ✔✔Proportioning Valve
, Before beginning a repair job, review the procedure in a: ✔✔Service Manual
Floating and sliding type disc brakes need a thin film of hi-temperature grease on the: ✔✔Slides
What can be used to secure brake caliper while rotor is being serviced? ✔✔Wire Hanger
What type wheel bearing is generally replaced as a unit? ✔✔Straight Roller Bearing
What components should be checked during a wheel bearing inspection? ✔✔Race and Rollers
What wheel bearing condition could be the result of lubricant failure? ✔✔Galling
When hand packing a wheel bearing, begin with a small amount of grease in: ✔✔Palm of Hand
What procedure should be followed when installing wheel bearing lock nut? ✔✔Torque to
Specifics
