Auto Final Exam Questions and Answers
Already Passed
Technician A says a load tester can be used to check the condition of a vehicles battery.
Technician B says a load tester can be used to check the condition of a vehicle starting system.
Who is right ✔✔Both a and B
What tool measures voltage overtime? ✔✔Oscilloscope
What tool is used when making a electrical test on a diesel engine ✔✔Luminosity timing meter
Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested.
Technician B says and inductive wire tracer checks for high current load in the circuit. Who is
right ✔✔Neither A nor B
Wire gauges in an automobile generally range from gauge 0 to gauge ___? ✔✔30
To protect wiring before it gets to the fuse block a what is installed ✔✔Fuse link
, Technician a says wiring spices are normally designated on automotive wiring diagrams buy a
dot. Technician B says a G can be used on some schematics to designate ground. Who is right?
✔✔Both a and B
The unit mill, used to measure wire diameter, is equal to ✔✔0.001
A set of several wires wrapped in tape or enclosed in a plastic sheath is referred to as a what
✔✔Wire harness
A late model auto Mobile may contain more than ___ wire to link electrical/electronic
components ✔✔1/4 mile
lowest resistance in ohms per 1000 feet ✔✔4
What is not important information conveyed by the wire code identification system ✔✔Wire
length
What is not a type of wiring diagram ✔✔Conductor resistance diagram
Already Passed
Technician A says a load tester can be used to check the condition of a vehicles battery.
Technician B says a load tester can be used to check the condition of a vehicle starting system.
Who is right ✔✔Both a and B
What tool measures voltage overtime? ✔✔Oscilloscope
What tool is used when making a electrical test on a diesel engine ✔✔Luminosity timing meter
Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested.
Technician B says and inductive wire tracer checks for high current load in the circuit. Who is
right ✔✔Neither A nor B
Wire gauges in an automobile generally range from gauge 0 to gauge ___? ✔✔30
To protect wiring before it gets to the fuse block a what is installed ✔✔Fuse link
, Technician a says wiring spices are normally designated on automotive wiring diagrams buy a
dot. Technician B says a G can be used on some schematics to designate ground. Who is right?
✔✔Both a and B
The unit mill, used to measure wire diameter, is equal to ✔✔0.001
A set of several wires wrapped in tape or enclosed in a plastic sheath is referred to as a what
✔✔Wire harness
A late model auto Mobile may contain more than ___ wire to link electrical/electronic
components ✔✔1/4 mile
lowest resistance in ohms per 1000 feet ✔✔4
What is not important information conveyed by the wire code identification system ✔✔Wire
length
What is not a type of wiring diagram ✔✔Conductor resistance diagram
