MAINTENANCE TECH II-III CONVENTIONAL 2024 QUESTIONS WITH VERIFIED SOLUTIONS ALREADY PASSED

MAINTENANCE TECH II-III CONVENTIONAL 2024 QUESTIONS WITH VERIFIED SOLUTIONS ALREADY PASSED 1. In what application is a splice closure used?: Splice clousures are used to protect optical fibers and splices against a full range of environmental changes inaerial installations or below ground in vaults 2. When preparing a fiber-optic cable for splicing, what is the purpose of removing approximately 2.5cm (1inch) ofjacket and any armor thatis present,from the end of the cable?: To acceas the cable rip cord and to chexk the cuttingdepth of the knife or ringing tool 3. What does water do to the glass core of an optical fiber?: Water causes the glass forebod the optical fiber to become opaque, which degreades the signal as it's transported through the fiber. 4. When preparing a splice closure, what should be done with the fiberglass rod strength member that runs down the center of the loose-tube fiber-opticcable?: Trim the strength member back for convenience, but leave it long enoughto be tightly clamped to a strain-relief lug in the closure 5. What is the purpose of splice tray inside a splice closures?: Splice trays aredesigned to provide protection for mechanical splices, fusion splice protectors, and optical spliters as well as provide storage foe the required fiber slack 6. How should the buffer tubes be secured in the closure?: The buffer tubesshould be secured with tie wraps to allow slight movement without pulling or stressing the optical fibers MAINTENANCE TECH II-III CONVENTIONAL 2024 QUESTIONS WITH VERIFIED SOLUTIONS ALREADY PASSED 7. How are the optical splices secured in a splice tray?: Retaining clip holdoptical splices in place in a aplice tray 8. What is the purpose of a buffer tubes in fiber-optic cables?: Buffer tubsprotect and separate the optical fiber in sallee bundles 9. When splicing fiber-optic cable, why is it a good safety practice to clean offfiber strippers and other hand tools after each use?: To prevent the accidentaltransfer of diber debris or fiber chips onto clean hands 10. Where would you expect to install a mid-entry splice in a fiber-optic cable next work?: A location where a select number of optixal fibers bees to be spliced, and the remaing buffer tubes and fibers remian untouched. 11. Which type of fusion splicer is ideal for fiber-to-the-x(FTTx) splicing?: Thefixed Vgroove spli