LATEST Maine State Inspection VERIFIED 100% SOLUTIONS

Minimum Brake Pedal Reserve - ANSWER 1/3 Transmission requirements - ANSWER Functioning Drive, Reverse, and Park Required Functional Malfunction indicator lights (Class A only) - ANSWER ABS, TPMS, Airbag,BRAKE Parking Brake Requirements - ANSWER Hold vehicle, Not connected to service brake system, no oil or grease on linings, must disengage Minimum Brake pad thickness - ANSWER 2/32" Maximum Brake pad crack depth - ANSWER 1/2 way through Reject vehicle if the brake pad surface is covered with this - ANSWER grease or oil Reject vehicle if brake discs or drums have these - ANSWER substantial cracks in friction surface, excessive rust, oil or grease contamination Reject vehicle if the inside diameter of the drum is: - ANSWER larger than the discard thickness stamped on the drum Reject vehicle if any brake disc thickness is: - ANSWER Thinner than the discard thickness stamped on the disc Hydraulic system components that must be free of leaks and structural rust - ANSWER Master cylinder, Reservoir, brake lines/hoses, ABS hydraulic unit, Calipers, Wheel Cylinders Power Assist Braking System Check - ANSWER Engine off- push pedal until it becomes firm. Start engine and ensure brake pedal drops slightly. How to test vacuum assist check valve - ANSWER After checking Power assist operation, shut engine off. Press brake pedal several times ensuring that 2 or 3 applications are assisted before pedal becomes stiff again. Exterior body component requirements - ANSWER Vehicle must have solid attached hood, doors, fenders, etc. Reject vehicle (Exterior) - ANSWER Rust holes in passenger area or structure. Inoperable door latches, Trunk area unsealed, Hood latch fails to operate. Exterior door handle removal requirements - ANSWER Must be able to manually open from inside of vehicle Reject vehicle (Exterior) - ANSWER Fenders do not cover tire tread, front or rear fenders removed, bumper replaced with less robust parts, missing bumpers. Minimum Brake Fluid level in reservoir - ANSWER 1/2 full Reject Vehicle (Fuel System) - ANSWER Missing fuel fill cap, Evaporator hose disconnected/broken Reject Vehicle (Fuel System) - ANSWER Fuel line rusted to near failure Seat Belts required in this year and newer - ANSWER 1966 Seat Mounting Requirements - ANSWER Mounted to floor, adjustable seats must stay in position Retractable Seat Belts required in this year and newer - ANSWER 1980 Battery requirements - ANSWER Must have functioning hold down system, not located in passenger compartment without proper cover Vehicles required to have splash guards - ANSWER 6000 lbs GVWR and up License Plate Requirements - ANSWER Must be current, horizontally mounted so as to be easily read, and be displayed front and rear.