Final Exam Key For MANE With Complete Solutions 2024

In Injection Molding, where do we add more material to the machine? - correct answer-Hopper What is the preferred drill size for a ½-14 NPT Pipe thread? - correct answer-23/32" In Cold Rolling, what is the initial width of the aluminum strips? - correct answer-0.7" In Dynamometer Lab, the minimum feed rate to be set is? - correct answer-0.002 in/rev If the floor around your machine is oily, what should you do? - correct answer-Protect other by cleaning up the spills immediately In Heat Treatment Lab, what are the 2 types of steel coupon used? - correct answer- Examples of personal protective equipment do not include - correct answer-Long-sleeve shirts In Metal Cutting Lab, what to do first if an accident happens when operating lathe? - correct answer-Push emergency stop In Sheet Metal Lab, the material property we investigate is? - correct answer-Formability In Injection Molding Lab, how many specimens are discarded before we can keep the sample specimens? - correct answer-3 In Forging Lab, what is the max pressure to be sued for forging (in psi)? - correct answer-1000 In Cold Rolling Lab, what is the length of the original aluminum strips? - correct answer-20 in What is the preferred drill size for a 1-8 UNC Tap? - correct answer-7/8" In Powder Metallurgy Lab, which of the following should be measure on the samples? - correct answer-Hardness In Dynamometer Lab, what is the maximum feed rate to be set? - correct answer-0.007 in/rev