General Tiaining N/odule
PART ONE
Yott ure advi,sed to spertd 20 minules on Qaestions l-ltl. First, reucl the tert bektv: rtntJ
otl,twer Questions l-8.
YOUR MOULEX IRON D Pressing button
This button activates a super shot of steam which
momentarily gives you an additional 409 of steam,
when needed.
lmportant: Do not use this more than five
successive times-
E Suits etc.
It is possible to use this iron in a vertical position
so that you can remove creases from clothes on
A Filling the reservoir coathangers or from curtains. Turning the
thermostat control and the steam button to
Your iron is designed to function using tap water. maximum, hold the iron in a vertical position close
However, it will last longer if you use distilled to the fabric but without touching it. Hold down the
water. pressing button for a maximum of one second. The
- Always unplug the iron before filling the steam produced is not always visible but is still
reservoir. able to remove creases.
- Always empty the reservoir after use. lmportant: Hold the iron at a sufficient distance
from silk and wool to avoid all risk of scorching.
B Temperature and steam control Do not attempt to remove creases from an item of
clothing that is being worn, always use a
Your Moulex iron has two buttons which control coathanger.
the intensity of heat produced by the iron. You can,
therefore, adjust the temperature of the iron and
the amount of steam being given off depending
F Auto-clean
upon the type of fabric being ironed. ln order that your iron does not become furred up,
* Turn the steam control to the desired intensity. Moulex have integrated an auto-clean system and
- Turn the thermostat control to the desired we advise you to use it very regularly (1-2 times
temperature. per month).
lmportant: lf your iron produces droplets of water - Turn the steam control to the off position.
instead of giving off steam, your temperature - Fill the reservoir and turn the thermostat control
control is set too low. to maximum.
- As soon as the indicator light goes out, unplug
C Spray button the iron and, holding it over the sink, turn the
steam control to auto-clean. Any calcium
This button activates a jet of cold water which deposits will be washed out by the steam.
allows you to iron out any unintentional creases. Continue the procedure until the reservoir is
Press the button for one second. empty.
94
, Part One
Questions 1-4
A[af ch tlrc picttLre,s, helow to the oppropriate ,section iri the in.strttttions. [Vrite the L'orre{'t
/etter A-F in bo.re,s I 4 rtn Nttur rtnsv'er sheet.
Questions 5-8
.,lnswer the fbllov,irtg questions on tlrc Moule.r irctn u,stitg N0 MORE THAN THREE
tyORDS. Write 1'om' fin,\v'ers itt boxes 5-8 ott v-oLtt' unswer ,vheet.
5 What sort of water are you advised to use?
6 Wliat lactor makes you decide on the quantity of steam to use?
7 What should you do if your iron starts to drip water?
8 What could clamage your iron if you clo not clean it?
9-S
PART ONE
Yott ure advi,sed to spertd 20 minules on Qaestions l-ltl. First, reucl the tert bektv: rtntJ
otl,twer Questions l-8.
YOUR MOULEX IRON D Pressing button
This button activates a super shot of steam which
momentarily gives you an additional 409 of steam,
when needed.
lmportant: Do not use this more than five
successive times-
E Suits etc.
It is possible to use this iron in a vertical position
so that you can remove creases from clothes on
A Filling the reservoir coathangers or from curtains. Turning the
thermostat control and the steam button to
Your iron is designed to function using tap water. maximum, hold the iron in a vertical position close
However, it will last longer if you use distilled to the fabric but without touching it. Hold down the
water. pressing button for a maximum of one second. The
- Always unplug the iron before filling the steam produced is not always visible but is still
reservoir. able to remove creases.
- Always empty the reservoir after use. lmportant: Hold the iron at a sufficient distance
from silk and wool to avoid all risk of scorching.
B Temperature and steam control Do not attempt to remove creases from an item of
clothing that is being worn, always use a
Your Moulex iron has two buttons which control coathanger.
the intensity of heat produced by the iron. You can,
therefore, adjust the temperature of the iron and
the amount of steam being given off depending
F Auto-clean
upon the type of fabric being ironed. ln order that your iron does not become furred up,
* Turn the steam control to the desired intensity. Moulex have integrated an auto-clean system and
- Turn the thermostat control to the desired we advise you to use it very regularly (1-2 times
temperature. per month).
lmportant: lf your iron produces droplets of water - Turn the steam control to the off position.
instead of giving off steam, your temperature - Fill the reservoir and turn the thermostat control
control is set too low. to maximum.
- As soon as the indicator light goes out, unplug
C Spray button the iron and, holding it over the sink, turn the
steam control to auto-clean. Any calcium
This button activates a jet of cold water which deposits will be washed out by the steam.
allows you to iron out any unintentional creases. Continue the procedure until the reservoir is
Press the button for one second. empty.
94
, Part One
Questions 1-4
A[af ch tlrc picttLre,s, helow to the oppropriate ,section iri the in.strttttions. [Vrite the L'orre{'t
/etter A-F in bo.re,s I 4 rtn Nttur rtnsv'er sheet.
Questions 5-8
.,lnswer the fbllov,irtg questions on tlrc Moule.r irctn u,stitg N0 MORE THAN THREE
tyORDS. Write 1'om' fin,\v'ers itt boxes 5-8 ott v-oLtt' unswer ,vheet.
5 What sort of water are you advised to use?
6 Wliat lactor makes you decide on the quantity of steam to use?
7 What should you do if your iron starts to drip water?
8 What could clamage your iron if you clo not clean it?
9-S
