Mold Remediation Contractor Test.100 Questions and Correct Answers, With Complete Solution 2024.

Mold Remediation Contractor Test.100 Questions and Correct Answers, With Complete Solution 2024. b. 10 feet The Texas Mold Assessment and Remediation Rules states that notice signs must be legible from: a. 5 feet b. 10 feet c. 15 feet d. 25 feet b. 6 months Upon completing any training course required by the Texas Mold Assessment and Remediation Rules, how long do you have to take and pass the state examination? a. 6 weeks b. 6 months c. 9 months d. 1 year a. 5 - 10 The assigned protection factor (PF) for an N-95 respirator is: a. 5 – 10 b. 20 – 30 c. 40 – 50 d. 60 – 70 e. There is no PF rating for an N-95 respirator a. Discard all books and papers b. Photocopy and discard originals c. Freeze or freeze-dry originals e. A., B. and C. above 4. According to the EPA’s “Mold Remediation in Schools and Commercial Buildings” document, the EPA recommends the following for cleanup of books and papers that were damaged with clean water within 24-48 hours: a. Discard all books and papers b. Photocopy and discard originals c. Freeze or freeze-dry originals d. None of the above e. A., B. and C. above d. Perform mold remediation 5. According to the Texas Mold Assessment and Remediation Rules, a Remediation Contractor is licensed to: a. Write a Mold Remediation Protocol b. Write a Mold Assessment c. Perform Clearance Testing d. Perform mold remediation e. Apply Biocides d. Full 6. According to Table 2 of the EPA’s “Mold Remediation in Schools and Commercial Buildings”, the containment recommended for a contaminated area of greater than 100 square feet is: a. None b. Minimum c. Limited d. Full c. Immediately cease all remediation work and implement emergency containment if necessary. 7. According to the Texas Mold Assessment and Remediation Rules, if a contractor is working under the Exceptions and Exemptions subsection and identifies additional mold that affects a total surface area of more than 25 contiguous square feet they shall: a. Continue working and hope no one notices. b. Immediately cease all remediation work and replace any contaminated materials so an assessment can be performed. c. Immediately cease all remediation work and implement emergency containment if necessary. d. Immediately cease all remediation work and contact the Department. c. An area that has been enclosed to control the release of mold or mold- containing vapors into the surrounding area. 8. According to the Texas Mold Assessment and Remediation Rules, a containment area is defined as: a. An area that has been enclosed to house violent criminals b. An area that has been enclosed to control the release of harmful vapors into the surrounding area. c. An area that has been enclosed to control the release of mold or mold- containing vapors into the surrounding area. d. An area that has been enclosed to control the release of chemicals into the surrounding area. c. Microbial growth 9. A musty odor indoors usually indicates: a. Mildewed laundry b. Moist conditions c. Microbial growth d. Poor housekeeping e. Wrong building materials a. Mold toxins and spores b. Dust mites c. Cleaning products e. A., B. and C. 10. Skin and eye protection during the remediation process is used to protect workers from: a. Mold toxins and spores b. Dust mites c. Cleaning products d. A. and B. e. A., B. and C. a. Less than one-half the outdoor spore count b. Less than one tenth the initial spore count before remediation c. Not more than 100 spores of any one type of mold d. No presence of toxigenic mold spores e. None of the above 11. According to the Texas Mold Assessment and Remediation Rules the required clearance level of mold spores is: a. Less than one-half the outdoor spore count b. Less than one tenth the initial spore count before remediation c. Not more than 100 spores of any one type of mold d. No presence of toxigenic mold spores e. None of the above a. Wet vacuuming b. Discarding d. HEPA vacuuming e. A., B. and D. above 12. According to the EPA’s “Mold Remediation in Schools and Commercial Buildings”, the recommended clean up method for carpet and backing with mold growth is: a. Wet vacuuming b. Discarding c. Damp wiping d. HEPA vacuuming e. A., B. and D. above a. Cleaned with a detergent solution 13. Non-porous hard surface areas can be: a. Cleaned with a detergent solution b. Should be disposed of c. Stored d. Remediated c. Avoid exposing workers and occupants to mold or mold contaminated dust 14. What is the highest priority or concern during a Mold Remediation Project: a. Removal of all mold and mold contaminated material b. Getting paid the full amount for the job c. Avoid exposing workers and occupants to mold or mold contaminated dust d. Saving all valuable items e. Not committing any Critical Level violations d. Discarded 15. According to the EPA’s “Mold Remediation in Schools and Commercial Buildings”, it is recommended that water damaged cellulose ceiling tiles should be: a. Tested b. Cleaned c. Stored d. Discarded c. $5,000 16. According to the Texas Mold Assessment and Remediation Rules, what is the maximum administrative penalty if a Mold Remediation Contractor does not use the containment specified in the Mold Remediation Protocol: a. $1,000 b. $2,500 c. $5,000 d. $7,500 e. $10,000 a. A licensed mold assessment consultant 17. According to the Texas Mold Assessment and Remediation Rules, who can write a mold management plan? a. A licensed mold assessment consultant b. A licensed mold assessment technician c. A licensed mold assessment contractor d. All of the above b. Supervise Mold Remediation Workers 18. According to the Texas Mold Assessment and Remediation Rules, a Mold Remediation Contractor may: a. Supervise Mold Assessment Technicians b. Supervise Mold Remediation Workers c. Perform Clearance Testing d. A. and B. above None of the above a. Hypersensitivity pneumonitis c. Rhinitis e. A and C above 19. Health effects from inhalation of mold spores could be: a. Hypersensitivity pneumonitis b. Toe nail infection c. Rhinitis d. All of the above e. A and C above a. Spores b. Hyphae c. Mycotoxins d. Living or dead fungi e. All of the above 20. According to the Texas Mold Assessment and Remediation Rules, a mold is defined as: a. Spores b. Hyphae c. Mycotoxins d. Living or dead fungi e. All of the above a. Determine the sources, locations and extent of mold growth in a building b. Determine the condition(s) that caused the mold growth c. Enable the assessment consultant to prepare a mold remediation protocol d. All of the above