WorkKeys Curriculum Graphic Literacy Level 5 Quiz
What is the range of tolerance grades for reaming?
A. Tolerance grade 5
B. Tolerance grades 5 through 9
C. Tolerance grades 6 through 10
D. Tolerance grades 6 through 11
C. Tolerance grades 6 through 10
The use of the 3-dimensional bars could give which of the following impressions that is not supported
by the raw data?
A. The difference between the gas and electric bills in February is double the difference between
those bills in March.
B. The largest difference between the gas and electric bills occurred in July.
C. The smallest difference between the gas and electric bills occurred in April.
D. The highest value of both the gas and electric bills was between $200 and $250.
A. The difference between the gas and electric bills in February is double the difference between
those bills in March.
Based on the table, one advantage to using 2×10 boards rather than 2×8 boards is that:
A. at a given load, the 2×10 boards can support a smaller span.
B. at a given load, the 2×10 boards can support a greater span.
C. at a given spacing, the 2×10 boards require less construction time.
D. at a given spacing, the 2×10 boards require less construction cost.
B. at a given load, the 2×10 boards can support a greater span.
The marketing department for a company that sells dietary supplements examines magazine
readership data. How many readers does Today's Woman have?
A. 35
B. 42
C. 3,500,000
D. 4,200,000
D. 4,200,000
After logic faults were introduced, how did the observed percentage of logic faults change as the
project moved from Phase 1 through Phase 4?
A. Increased only
B. Decreased only
What is the range of tolerance grades for reaming?
A. Tolerance grade 5
B. Tolerance grades 5 through 9
C. Tolerance grades 6 through 10
D. Tolerance grades 6 through 11
C. Tolerance grades 6 through 10
The use of the 3-dimensional bars could give which of the following impressions that is not supported
by the raw data?
A. The difference between the gas and electric bills in February is double the difference between
those bills in March.
B. The largest difference between the gas and electric bills occurred in July.
C. The smallest difference between the gas and electric bills occurred in April.
D. The highest value of both the gas and electric bills was between $200 and $250.
A. The difference between the gas and electric bills in February is double the difference between
those bills in March.
Based on the table, one advantage to using 2×10 boards rather than 2×8 boards is that:
A. at a given load, the 2×10 boards can support a smaller span.
B. at a given load, the 2×10 boards can support a greater span.
C. at a given spacing, the 2×10 boards require less construction time.
D. at a given spacing, the 2×10 boards require less construction cost.
B. at a given load, the 2×10 boards can support a greater span.
The marketing department for a company that sells dietary supplements examines magazine
readership data. How many readers does Today's Woman have?
A. 35
B. 42
C. 3,500,000
D. 4,200,000
D. 4,200,000
After logic faults were introduced, how did the observed percentage of logic faults change as the
project moved from Phase 1 through Phase 4?
A. Increased only
B. Decreased only
