ANSWERS 100% CORRECT | GRADED A+
What is the primary function of IMSA?
a. Teaching design issues
b. Safety education
c. Signal manufacturing training
d. Install traffic signals - ✔✔b
IMSA stands for? - ✔✔International Municipal Signal Association
Which of the following is not an IMS a certification? A traffic signal level to
design technician be traffic signal level to field technician see traffic signal
level to bench technician D traffic signal level III bridge design technician -
✔✔D
Which of the following are potential safety hazard's? A overhead and
underground power be gas see aerial lift equipment D all of the above -
✔✔D
, What are the sections of a ramp meter signal? A circular red circular yellow
circular green be a circular yellow, circular green sea. Circular read, circular
yellow D. Circular read, circular yellow - ✔✔D
PPE stands for: - ✔✔Personal protective equipment
Which of the following is an example of adequate fall protection during the
operation of aerial lift equipment? A. Full body harness be. Safety belt see.
Rails of a platform lift D. All of the above - ✔✔D
A work zone supervisor is responsible for which of the following tasks: a.
Maintaining the project schedule B. Ensure advance warning devices have
not been removed or relocated see. Enforce traffic laws in the work zone D.
All of the above - ✔✔B
Which of the following is not a sentence type in the MUTCUD: a standards
be guidance C. objectives D support - ✔✔C
Which of the following is an example configuration of an emergency vehicle
traffic control signal: a two section traffic signal with circular green and
circular read indications beer. Three section traffic signal with circular read,
circular yellow, and smaller circular yellow indications see. Two section
traffic signal with circular green and circular yellow indications D. None of
the above - ✔✔B