Home Inspector Multiple Choice Study guide Exam 2024 questions and answers

Home Inspector Multiple Choice Study guide Exam 2024 questions and answers T/F: The inspector is required to inspect the damper doors by opening and closing them, if readily accessible and manually operable. False True - CORRECT ANSWER-True The inspection is _________ chimney and fireplace structure, systems and components. A. an all-inclusive and technically exhaustive evaluation of the B. a visual-only evaluation of the accessible - CORRECT ANSWER-B T/F: The inspector should look at the general structure of the chimney and any connections to appliances, stoves, and heating systems. False True - CORRECT ANSWER-True T/F: The inspector should advise his/her client that all fireplaces, fuel-burning stoves, and chimneys should be inspected by a certified chimney sweep prior to their first use, and not less than annually. True False - CORRECT ANSWER-True Footings for masonry fireplaces must extend _____ the frost line. A. above B. down to C. below - CORRECT ANSWER-C Open spaces between the chimney wall and the combustible building materials should be sealed and insulated with _____ material. A. cellulose B. non-combustible C. wood shims - CORRECT ANSWER-B A masonry chimney should extend at least _____ feet above the highest point where the chimney passes through the roof, and _____ feet above any portion of a building that is within a _____-foot distance horizontally. A. 3, 2, 10 B. 3, 10, 2 C. 2, 3, 10 - CORRECT ANSWER-A Inlets to masonry chimneys must enter from the _____. A. side B. top C. bottom - CORRECT ANSWER-A T/F: Gas vents that are greater than 12 inches in size or that are located less than 8 feet from a vertical wall or similar structure should terminate at least 2 feet above the highest point where they pass through the roof, and not less than 2 feet above any portion of a dwelling within 10 feet horizontally. True False - CORRECT ANSWER-True T/F: A greater height for a fuel-gas vent above the roof is needed as the roof pitch approaches being a vertical surface. True False - CORRECT ANSWER-True T/F: It is a common mistake to apply height requirements for chimney terminations (such as the 3-2-10 Rule) to fuel vents that cause them to extend above roofs much higher than needed, in most cases. False True - CORRECT ANSWER-True T/F: The venting system is permitted to extend into or pass through a fabricated air duct or furnace plenum. True False - CORRECT ANSWER-False T/F: A cast-in-place chimney flue liner is made of a lightweight, cement-like product installed inside the chimney. True False - CORRECT ANSWER-True A cast-in-place lining ____ help correct the structural integrity of an old chimney. A. can B. cannot - CORRECT ANSWER-A Metal chimney flue liners are usually made of _____ or aluminum. A. fiberglass B. plastic C. cast iron D. stainless steel - CORRECT ANSWER-D T/F: Stainless steel flue lining is suitable for wood-burning, gas, or oil applications. False True - CORRECT ANSWER-True Clay tiles are the _____ common type of masonry chimney liner. A. most B. least - CORRECT ANSWER-A T/F: Chimneys should extend at least 2 feet higher than any portion of a building within 10 feet, but shall not be less than 3 feet above the highest point where the chimney passes through the roof. True False - CORRECT ANSWER-True Type L venting systems should terminate with a listed and labeled cap at least _____ feet above the roof and at least _____ feet above any portion of the building within _____ feet. A. 2, 2, 10 B. 3, 2, 10 C. 10, 2, 2 - CORRECT ANSWER-A T/F: It may be difficult to tell the difference between Type L and Type B ven