QUESTIONS AND ANSWERS 2024 UPDATE 100% CORRECT
GRADE A+
The installation commander assigns one person as the POC for all ESMP
activities. Which role does that person fill?
Occupational Health and Safety Manager
Colonel hires you as the occupational safety and health manager by what reg?
DA PAM 385-64
Which two of these could have generated the UXO?Select all that apply.
in combat, live fire range
You get a call from the live fire range that someone suspects they've found UXO.
Which three of these things do you tell them to do?
-don't touch
-keep away
-Contact the proper authorities
ammo life cycle field
RDT&E, production, storage, ASP, range
ammo life cycle theater
port, storage, ASP, AHA, operational units
DDESB's mission
-advise the Secretary of Defense and the Services about ESP progress and challenges
annually.
-Create and maintain the DoD ESP.
-provide ESP oversight and technical expertise to the Services.
cardinal rule
minimum amount of explosives for the minimum amount of time.
Your role is to ensure the safety and serviceability of the stockpile and monitor
AE uploads, transportation, and storage activities. Who are you?
QASAS
You have been appointed as your installation's safety chief. Who is responsible
for developing, implementing, and managing the ESP as part of the overall safety
and occupational health program for the installation?
installation commander
If you are responsible for assisting commanders and staff with resolving
explosives safety concerns, which role do you have?
safety specialist
You are assigned to support tactical units regarding execution of ESMP. Who are
you?
Ammo Warrant Officer
Ammunition that is old, doesn't work, or is otherwise unusable belongs in which
life cycle stage?
demilitarization
document check list
, DoDD 6055.09E, DoDI 6055.16, AR 385-10, DoDD 6055.09M, DA PAM 385-64
You are working on new explosives safety guidelines for the Army. What is the
key principle you must remember when applying Service publication safety
standards?
service standards can be more restrictive but not less than DoD
Based on what you just learned about the different publications, where would you
go to find the minimum level of protection all Services must provide for
explosives safety?
DESR 6055.09
advantages of DU
hard, easy to fabricate, dense, inexpensive, pyro
calibers of DU
20mm, 25mm, 30mm, 105mm, 120mm
What is the primary hazard for HC 1.1?
mass detonation
Which placard must be attached to a load with a primary hazard of mass fire?
1.3
Which placard indicates fragmentation as the primary hazard?
1.2
Which placard must be displayed on a vehicle transporting a load of ammunition
with a moderate risk of fire?
1.4
What are four uses for DU?
-aircraft counterweight
-kinetic energy projectile
-protective armor plating
-radiation shield material
basic ops inside an ammo magazine
banding and marking
basic ops outside an ammo magazine
removing grommets, plugs; air testing; unpacking
An organization on your installation is preparing to deploy. Your team must
prepare the ammo for them. Which operations are you permitted to do INSIDE a
magazine?
inventory, inspecting, shipping
You must remove and replace grommets on AE at an ECM. How far from the
exterior side of the ECM do you have to perform this task?
50ft
You are tasked to unpack, link, and repack SAA at an AGM. How far from the AGM
do you have to be to perform this task?
100ft
You are inspecting an AGM and the ammo is stacked pretty high. What is the
minimum required distance it can be stacked from the ceiling?
18 inches
You know the safety office is conducting random inspections of magazines.
Which of these ammunition storage guidelines apply?