MSF MOTORCYCLE SAFETY FOUNDATION eCOURSE 2024
UPDATE COMPREHENSIVE QUESTIONS AND VERIFIED
ANSWERS GRADE A+
The E in FINE-C is for
Engine cut-off switch means put the switch in the Run/On position.
The C in FINE-C is for
Choke and Clutch, means to set the choke and squeeze in the clutch lever. The choke
should be On for a cold engine, although some motorcycles do not have a choke.
Always apply at least one _________ when starting the engine.
Brake.
Do not use the ________ if the _________ is On as this could provide too much
fuel to the engine.
throttle, choke
Once the engine is started, you can release the _________ lever, but do so slowly
in case the motorcycle is not in _________.
FINE-C Refers to
an engine pre-start routine.
FINE-C stands for,
Fuel, Ignition, Neutral, Engine cut-off switch, Choke and Clutch.
The F in FINE-C means to..
Fuel, if equipped, means to turn the fuel supply valve on.
The I in FINE-C is for
Ignition, means turn the ignition switch to the On position. Some indicator lights should
come on.
The N in FINE-C is for
Neutral, means to be in Neutral. The green light in the instrument cluster "indicates"
neutral. When in neutral, the motorcycle will roll forward and backward with the clutch
lever and front brake lever released.
clutch, neutral
Do not take your hand off the ________ when starting the engine of a motorcycle
because the motorcycle may be in gear.
clutch,
The throttle is located on
The right hand grip.
To roll on the throttle means to,
twist the throttle Towards You.
The clutch level is located on
The left hand grip.
When you squeeze in the clutch,
there is no power going to the rear wheel.
The gearshift is located on
the left footrest.
To use the gearshift,
, Lift your foot up for a higher gear, and press down for a lower gear.
Whens shifting gears, your foot only needs to move up or down _________
an inch or so.
Most motorcycles have how many gears?
5 or 6
Neutral gear is located in between which gears?
First and second gear.
The fuel supply valve is located
under the Engine.
What does the fuel supply valve do?
The fuel supply valve controls the amount of fuel to the engine tank
The Ignition Switch is often located near the
instrument cluster.
Positions on the ignition switch include
On, Off and Lock, and some include a Park position.
The Lock and Park positions on an ignition switch...
engage the steering lock and allow the key to be removed.
The Park position on the ignition switch..
turns on the taillight for better visibility when parked for a short time on the side of the
road.
The Choke Control is located
on the handlebars or near the engine.
What does the choke control do?
It provides an enriched fuel mixture to help start a cold engine. It also raises the idle to
permit the engine to warm quickly. It should be turned Off as soon as the engine idles
smoothly without it.
Fuel Injected motorcycles do or not have a choke control?
They do not.
Where is the engine cut-off switch?
The Engine Cut-Off Switch can be found near the right handgrip and is operated with
the thumb.
What does the engine cut-off switch do?
It allows you to shut off the engine without removing your hand from the handgrip.
The Turn Signal Switch is usually located
near the left handgrip and is operated with the thumb.
The High-Low Beam Switch is near
the left handgrip and is operated with the thumb.
The Horn Button is located near
the left handgrip and operated with the thumb.
The Engine Start Button is usually located
near the right handgrip and is operated with the thumb.
The speedometer
a portion of the instrument cluster that measures road speed.
The Tachometer
indicates engine speed in revolutions per minute or RPM. It has a red zone for
maximum engine speed that should never be exceeded.`
UPDATE COMPREHENSIVE QUESTIONS AND VERIFIED
ANSWERS GRADE A+
The E in FINE-C is for
Engine cut-off switch means put the switch in the Run/On position.
The C in FINE-C is for
Choke and Clutch, means to set the choke and squeeze in the clutch lever. The choke
should be On for a cold engine, although some motorcycles do not have a choke.
Always apply at least one _________ when starting the engine.
Brake.
Do not use the ________ if the _________ is On as this could provide too much
fuel to the engine.
throttle, choke
Once the engine is started, you can release the _________ lever, but do so slowly
in case the motorcycle is not in _________.
FINE-C Refers to
an engine pre-start routine.
FINE-C stands for,
Fuel, Ignition, Neutral, Engine cut-off switch, Choke and Clutch.
The F in FINE-C means to..
Fuel, if equipped, means to turn the fuel supply valve on.
The I in FINE-C is for
Ignition, means turn the ignition switch to the On position. Some indicator lights should
come on.
The N in FINE-C is for
Neutral, means to be in Neutral. The green light in the instrument cluster "indicates"
neutral. When in neutral, the motorcycle will roll forward and backward with the clutch
lever and front brake lever released.
clutch, neutral
Do not take your hand off the ________ when starting the engine of a motorcycle
because the motorcycle may be in gear.
clutch,
The throttle is located on
The right hand grip.
To roll on the throttle means to,
twist the throttle Towards You.
The clutch level is located on
The left hand grip.
When you squeeze in the clutch,
there is no power going to the rear wheel.
The gearshift is located on
the left footrest.
To use the gearshift,
, Lift your foot up for a higher gear, and press down for a lower gear.
Whens shifting gears, your foot only needs to move up or down _________
an inch or so.
Most motorcycles have how many gears?
5 or 6
Neutral gear is located in between which gears?
First and second gear.
The fuel supply valve is located
under the Engine.
What does the fuel supply valve do?
The fuel supply valve controls the amount of fuel to the engine tank
The Ignition Switch is often located near the
instrument cluster.
Positions on the ignition switch include
On, Off and Lock, and some include a Park position.
The Lock and Park positions on an ignition switch...
engage the steering lock and allow the key to be removed.
The Park position on the ignition switch..
turns on the taillight for better visibility when parked for a short time on the side of the
road.
The Choke Control is located
on the handlebars or near the engine.
What does the choke control do?
It provides an enriched fuel mixture to help start a cold engine. It also raises the idle to
permit the engine to warm quickly. It should be turned Off as soon as the engine idles
smoothly without it.
Fuel Injected motorcycles do or not have a choke control?
They do not.
Where is the engine cut-off switch?
The Engine Cut-Off Switch can be found near the right handgrip and is operated with
the thumb.
What does the engine cut-off switch do?
It allows you to shut off the engine without removing your hand from the handgrip.
The Turn Signal Switch is usually located
near the left handgrip and is operated with the thumb.
The High-Low Beam Switch is near
the left handgrip and is operated with the thumb.
The Horn Button is located near
the left handgrip and operated with the thumb.
The Engine Start Button is usually located
near the right handgrip and is operated with the thumb.
The speedometer
a portion of the instrument cluster that measures road speed.
The Tachometer
indicates engine speed in revolutions per minute or RPM. It has a red zone for
maximum engine speed that should never be exceeded.`
