API 1169. Study test questions test RM#2 with 100% Correct Answers

API 1169. Study test questions test RM#2 with 100% Correct Answers According to OSHA a "protective system" is defined as: - Answer- Method of protecting employees from cave-ins. Design and development inputs shall be identified and reviewed for? - Answer- Accuracy, completeness and lack of conflict The Excavator calls the One Call Center prior to excavation at least - Answer- Two working days nor more than ten working days Encroachment Area is the area where the ground disturbance occurs within: - Answer- 50 feet of the centerline of the existing facility (or ROW) or other easement The pressure recorders and deadweight gauge shall be located at a safe distance at least: - Answer- 100 feet from the facility being tested In compliance with the Uniform Color Code the route and or area to be excavated shall be identified by: - Answer- White markers Markings may include one or any combination of the following: paint, chalk, flags, stakes, brushes, or offsets. Matching markings to existing and expected surface conditions is the responsibility of? - Answer- Facility Owner Subpart G of 49CFR192 prescribes minimum requirements for: - Answer- Construction of transmission pipelines and mains. If a newspaper was seeking information about the project, are inspection personnel allowed to interac with them to answer their questions? - Answer- Only if expressly allowed Before placing new gas pipelines in service all piping and components must be subjected to: - Answer- 125% of MOP (maximum operational pressure) of the system for 4 hours A detailed design developed from operating requirements and conforming to Code requirements including all necessary drawings and specifications, goveming a liquid petroleum pipeline installation is also known as? - Answer- Engineering design Planned, systematic, and preventative actions that are required to ensure that materials, products and services will meet specified requirements is called? - Answer- Quality Control system Any physical objects detected by an in-line inspection device that may be anomalies, components, nearby metallic objects, or some other item are also known as? - Answer- Features Which describes "rework" the best? - Answer- Any grinding or welding on a completed weld to correct potentially rejectable indications General basic requirements for Chief Inspector qualification are? - Answer- Environmental and pollution control What type of hazard is a waterway crossing? - Answer- Site-Specific What would a continuous run of pipe between adjacent blocks valves be called? - Answer- A pipeline section Does a section of pipe removed and scheduled for reuse, but then reinstalled in the same loca need to be retested? - Answer- No testing required In intemational codes and standards, this is often referred to as the maximum steady state op pressure or maximum allowable operating pressure - Answer- Operating pressure limit The letter "I" identifies shipping names appropriate for: - Answer- .Describing materials in intermational transportation Who is responsible for all safety on the job site? - Answer- Contractor What identifies hazards that necessitate the use of PPE? - Answer- JSA Which is an example of a sustained load? - Answer- The weig