CSA W59 WELDING INSPECTOR LEVEL 1 QUESTIONS WITH 100% CORRECT ANSWERS { GRADED A+}

CSA W59 WELDING INSPECTOR LEVEL

1 QUESTIONS WITH 100% CORRECT

ANSWERS { GRADED A+}




3.1 Contractors




In the absence of specific requirements in the governing design standard

, at the option of the engineer what other standards shall the contractor

be certified too ? If no standard is required what shall the contractor

prove ? - ✔✔W47.1


The contractor must prove their compentency to the engineer.

3.1.2 Welding processes

,What processes are covered by this standard ? - ✔✔SMAW, GMAW,

MCAW, FCAW, SAW, ESW, EGW, SW

Filler metals and allied materials are classified under what standard ? -

✔✔CSA W48


What processes filler metals and other materials not covered under CSA

W48? - ✔✔Stud welding is not covered under CSA W48. It shall

conform to the requirements of clause 3.1.2.2

Any welding process not covered by CSA W59 or not written into this

standard shall be covered under the acceptance criteria of what other

standard ? - ✔✔CSA W47.1


3.1.3 Prequalified joints




What processes are deemed pre qualified as long as they conform to

what clause ? And therefore are approved for use with out joint welding

qualification providing that welding procedures also conform to clause

, 4,5,10 - ✔✔SMAW, SAW, FCAW, MCAW (spray transfer) and

GMAW (spray transfer) as long as they conform to clause 10 shall be

deemed as prequalified .

3.2 Base metal




Steel base metal to be welded under this standard shall conform to what

standard?




*equivalent welding quality shall be established on the basis of

composition and carbon equivalent - ✔✔Steel material to be welded

should conform to CSA or ASTM requirements

What CSA standard shall steel base metal that is to be welded conform

to ? - ✔✔CSA G40.21


4.1 Design of welded connections