Answers | Verified | Latest 2024 Version
NATOPS publications provide the best available operating instructions for ______. However, no manual
can cover everything situation or be a substitute for _____; operational situations may require
modification of the procedures contained therein. Read these products thoroughly. As an aircrew
member, it is your responsibility to have a ____ knowledge of their contents. - ✔✔Most circumstances,
sound judgement, complete
Which is not a defined change recommendation for NATOPS changes? - ✔✔Immediate
Revised text is indicated by a _____ in the outside margin of the page. - ✔✔Black vertical line
Explanatory information about an operating procedure, practice, or condition, etc., that may result in
damage to equipment if not carefully observed or followed. - ✔✔Caution
Explanatory information about an operating procedure, practice or condition, etc., that may result in
injury, or death, or loss of aircraft if not carefully observed or followed. - ✔✔Warning
Explanatory information about an operating procedure, practice, or condition, etc., that must be
emphasized. - ✔✔Note
__________ means extended flight is not recommended. The landing sight and duration of flight are at
the discretion of the pilot in command. - ✔✔LAND AS SOON AS PRACTICABLE
The MH-60R primary mission include _______ - ✔✔SUW, ASW, EW, CC, NCO
Secondary missions include ______, Air warfare (AW; e.g LSF) Health services (HS e.g. MEDIVAC), Fleet
support -Operations (FS-O e.g. SAR) _____, Logistics (LOG; e.g. VERTREP) Combat Search and Rescue
(CSAR) - ✔✔Amphibious Warfare (AMW; e.g. Naval Surface Fire Support), Intelligence Operations (INT;
e.g. ISR)
______ significantly reduces the field of view and the success rate of obtaining visual contact with a
survivor when performing SAR lookout duties from the SO window. Due to the visual restrictions,
,dedicated SAR missions should consider removal of the _____ to enhance probability of detection /
sighting of survivor - ✔✔Left hand extended pylon
Use of the sonobuoy launcher window is _____ - ✔✔Prohibited
The center rear seat shall be removed if ____ - ✔✔RAST probe is installed
The Simula seat ______ be removed during flights not requiring its use. When installed the Simula seat
creates an egress hazard for the Aircrewman. - ✔✔Should
The primary passenger seat is the ____ seat position during single passenger flights. - ✔✔Instructor
The center rear seat ____ be removed if RAST probe is installed. The RAST probe prevents proper
stroking of the seat in the event of a crash. - ✔✔Shall
All essential engine electrical functions are powered by the ____. The engine ____ contains separate
windings providing AC power to the igniter assembly, DECU, and Ng signal to the vertical instruments. -
✔✔Alternator
The ____ attenuates the magnitude and reduces the duration of the peak vibratory loads produced by
the main rotor at the main rotor blade passage vibration frequency. - ✔✔AVCS - Active vibration control
system
In flight or on deck, the instantaneous nature of the AVCS commanded vibrations can sometimes cause a
vibration spike or a "_____" that is felt throughout the aircraft. It can range in intensity from barely
noticeable to extremely uncomfortable and excessive. - ✔✔Bump
Water-contaminated fuel may cause fluctuations/surges in one or both engines with no associated ____
or ____ caution. - ✔✔FUEL PRESS / FUEL FLTR BYPASS
A pressure refueling port is provided for standard ___-PSI pressure refueling on the ground without
electrical power. - ✔✔55
, The minimum accumulator pressure required for starting the APU is approximately __ PSI. It can be
recharged using the accumulator hand pump. With AC power available, the accumulator is charger by
the backup hydraulic pump. - ✔✔2,650
With a __ percent charge, normal battery life is 11 minutes for day operations and 9 minutes for night
operations - ✔✔80
During normal system operation, the selection of certain hydraulic systems and Automatic Flight Control
System (AFCS) functions may result in the ____ of the related cautions. - ✔✔Intermittent appearance
The central component of the AFCS is the ____. - ✔✔digital AFCC
The crew hover function is activated from the AFCS CONTROL panel by depressing the CREW HVR push
button. It can only be achieved if the ____ is already engaged. - ✔✔Hover coupler mode
The crew hover trim grip has a control authority of +/- ____ KGS laterally and longitudinally about the
reference values selected on the LONG VEL and LAT VEL in addition to the speed set by the cyclic four-
way TRIM switch - ✔✔5
If the ___ outer ring is reached while the dome is in the water, there is a significantly increased risk of
the dome striking the aircraft including the aircraft rotors which may result in aircrew injury and/or
death. - ✔✔8.5 degree
The potentiometers on this panel are used to bias the cable angle sensors away from the preset
manufacturer cable angle sensor calibration and should normally not require adjustment. In most cases,
these potentiometers should be set at zero (at the ___ o'clock position) prior to flight and not adjusted: -
✔✔12
Conditions required for cable angle hover mode engagement are ground speed of +/- ____ knots,
altitude hold within ___ feet of selected altitude, and ____ indication. - ✔✔ / dome wet
Adjustment of the pots during the first __ seconds may counter the AFCCs correction calculation, and
can result in damage to the transducer or sonar cable. Use of this potentiometer does not guarantee the
cable will center. - ✔✔25