California ICC Technician
1. I do a ____ after replacing a spout to a Healy 900 nozzle - ANS-shut off test
2. In a balance hose the gasoline flows in - ANS-Inner hose
3. After the installation of the vapor piping and before back filling, PEI 300 suggests
some methods to document piping layout, except? - ANS-Drawing with a pen, pipe
layout on the cover of the tank manual.
4. During VO-1000 you don't - ANS-Work without eye protection
5. An Overfill Alarm device needs to be located - ANS-Where it can be heard or seen by
the delivery location.
6. When in a GDF you can avoid the installation of UDC? - ANS-No exceptions of any
GDF.
7. What is considered an Underground Storage Tank? - ANS-Tank and pipping only
8. Gasoline vapors are 3/4 times _____ than air - ANS-Heavier
9. Compounds with a high vapor pressure such as gasoline will evaporate readily and
will typically - ANS-Have a low Flashpoint.
10. The ____ is the valve that controls pressure and vacuum on the tank. - ANS-P/V
Valve
11. The vapor piping must be all, but not - ANS-Compatible with underground
environment.
12. The Shear Valve is installed ____ - ANS-At the base of the dispenser.
13. What is the max length of a Healy Hose Phase 2? - ANS-20 Feet.
14 A ___ is a component of the hanging hardware that separates when it's applied a
force? - ANS-Breakaway.
, 15. UL listed means all except : - ANS-Worldwide Approved.
16. After a drive off, a technician should not - ANS-Ask attendant to fill out a drive off
accident report.
17. The executive order 201-A says that the reconnection of the breakaway needs to be
- ANS-Logged in the maintenance GDF.
18. What is not a secondary containment testing method? - ANS-Statistical Inventory
Reconciliation.
19. The air clean seperator must be located in the GDF - ANS-No more than 100 ft from
the vent riser.
20. The PEI-500 recommends that to avoid being shocked by electricity or soaked with
gasoline that? - ANS-You must disconnect power to all electric devices.
21. Which of these refer to a vapor recovery stage 1? - ANS-Delivery of gasoline and
UST.
22. Which is not part of the hanging hardware? - ANS-Shear Valve
23. What is not apart of a stage 2 vapor recovery? - ANS-Monitoring equipment
24. To install a Healy Z083B Vapor Vac Kit you need the following tools except -
ANS-Stretching copper tool
25. After July 1 2004 continuous monitoring on secondary containment is required on? -
ANS-Tanks, sumps, UDC where single wall pipe is present.
26. The 1/8 inch of foot slope in vapor pipping may not be applied if? - ANS-Should
always apply to avoid blocks.
27. What is the minimum nominal internal diameter for a vapor riser stage 2? - ANS-1"
28. What should you do in case of a large spill and you are waiting for the emergency
response? - ANS-Try to clean and contain the spill as much as possible.
29. A secondary containment on vent lines is not required if? - ANS-A ball float will stop
delivery at 90% tank capacity.
1. I do a ____ after replacing a spout to a Healy 900 nozzle - ANS-shut off test
2. In a balance hose the gasoline flows in - ANS-Inner hose
3. After the installation of the vapor piping and before back filling, PEI 300 suggests
some methods to document piping layout, except? - ANS-Drawing with a pen, pipe
layout on the cover of the tank manual.
4. During VO-1000 you don't - ANS-Work without eye protection
5. An Overfill Alarm device needs to be located - ANS-Where it can be heard or seen by
the delivery location.
6. When in a GDF you can avoid the installation of UDC? - ANS-No exceptions of any
GDF.
7. What is considered an Underground Storage Tank? - ANS-Tank and pipping only
8. Gasoline vapors are 3/4 times _____ than air - ANS-Heavier
9. Compounds with a high vapor pressure such as gasoline will evaporate readily and
will typically - ANS-Have a low Flashpoint.
10. The ____ is the valve that controls pressure and vacuum on the tank. - ANS-P/V
Valve
11. The vapor piping must be all, but not - ANS-Compatible with underground
environment.
12. The Shear Valve is installed ____ - ANS-At the base of the dispenser.
13. What is the max length of a Healy Hose Phase 2? - ANS-20 Feet.
14 A ___ is a component of the hanging hardware that separates when it's applied a
force? - ANS-Breakaway.
, 15. UL listed means all except : - ANS-Worldwide Approved.
16. After a drive off, a technician should not - ANS-Ask attendant to fill out a drive off
accident report.
17. The executive order 201-A says that the reconnection of the breakaway needs to be
- ANS-Logged in the maintenance GDF.
18. What is not a secondary containment testing method? - ANS-Statistical Inventory
Reconciliation.
19. The air clean seperator must be located in the GDF - ANS-No more than 100 ft from
the vent riser.
20. The PEI-500 recommends that to avoid being shocked by electricity or soaked with
gasoline that? - ANS-You must disconnect power to all electric devices.
21. Which of these refer to a vapor recovery stage 1? - ANS-Delivery of gasoline and
UST.
22. Which is not part of the hanging hardware? - ANS-Shear Valve
23. What is not apart of a stage 2 vapor recovery? - ANS-Monitoring equipment
24. To install a Healy Z083B Vapor Vac Kit you need the following tools except -
ANS-Stretching copper tool
25. After July 1 2004 continuous monitoring on secondary containment is required on? -
ANS-Tanks, sumps, UDC where single wall pipe is present.
26. The 1/8 inch of foot slope in vapor pipping may not be applied if? - ANS-Should
always apply to avoid blocks.
27. What is the minimum nominal internal diameter for a vapor riser stage 2? - ANS-1"
28. What should you do in case of a large spill and you are waiting for the emergency
response? - ANS-Try to clean and contain the spill as much as possible.
29. A secondary containment on vent lines is not required if? - ANS-A ball float will stop
delivery at 90% tank capacity.
