Woodshop Test Study Guide
Compound Miter Saw - CORRECT ANSWER-cross cutting tool that makes miter &
bevel cuts.
Drill Press - CORRECT ANSWER-a tool for drilling holes.
Bandsaw - CORRECT ANSWER-a tool to cut detailed shapes in thick material.
Scroll Saw - CORRECT ANSWER-a tool to cut detailed shapes into thin material.
MOS for Compound Miter Saw - CORRECT ANSWER-3-6 in.
MOS for Drill Press - CORRECT ANSWER-2 in. on either side of the drill bit.
MOS for Bandsaw - CORRECT ANSWER-2 in. on either side of the blade.
MOS for Scroll Saw - CORRECT ANSWER-don't go past the guard.
The trigger for the CMS does this: - CORRECT ANSWER-rotates the tool
The handle for the CMS does this: - CORRECT ANSWER-makes the tool go up and
down
CMS: 1. The CMS should be _______ to the workbench. - CORRECT
ANSWER-secured
CMS: 2. Hold the material with your left hand tight to the _____ and _____. -
CORRECT ANSWER-table, fence
CMS: 3. Start the tool prior to ________ the blade with the stock. - CORRECT
ANSWER-engaging
CMS: 4. Keep the trigger pressed until the saw is __________ _______ ___ _____. -
CORRECT ANSWER-completely through the stock
CMS: 5. Do not ___ __ __ ___ ______ until the blade has been raised above the
stock. - CORRECT ANSWER-let go of the handle
Compound Miter Saw - CORRECT ANSWER-cross cutting tool that makes miter &
bevel cuts.
Drill Press - CORRECT ANSWER-a tool for drilling holes.
Bandsaw - CORRECT ANSWER-a tool to cut detailed shapes in thick material.
Scroll Saw - CORRECT ANSWER-a tool to cut detailed shapes into thin material.
MOS for Compound Miter Saw - CORRECT ANSWER-3-6 in.
MOS for Drill Press - CORRECT ANSWER-2 in. on either side of the drill bit.
MOS for Bandsaw - CORRECT ANSWER-2 in. on either side of the blade.
MOS for Scroll Saw - CORRECT ANSWER-don't go past the guard.
The trigger for the CMS does this: - CORRECT ANSWER-rotates the tool
The handle for the CMS does this: - CORRECT ANSWER-makes the tool go up and
down
CMS: 1. The CMS should be _______ to the workbench. - CORRECT
ANSWER-secured
CMS: 2. Hold the material with your left hand tight to the _____ and _____. -
CORRECT ANSWER-table, fence
CMS: 3. Start the tool prior to ________ the blade with the stock. - CORRECT
ANSWER-engaging
CMS: 4. Keep the trigger pressed until the saw is __________ _______ ___ _____. -
CORRECT ANSWER-completely through the stock
CMS: 5. Do not ___ __ __ ___ ______ until the blade has been raised above the
stock. - CORRECT ANSWER-let go of the handle
