ASPHALT PAVING LEVEL 1 EXAM WITH LATEST QUESTIONS AND CORRECT ANSWERS ALREADY GRADED A+ ()

ASPHALT PAVING LEVEL 1 EXAM WITH LATEST QUESTIONS AND CORRECT ANSWERS ALREADY GRADED A+ (2024- 2025) A full lot of super pave asphalt is what size? 1,000 tons 1,000 to 2000 tons 2000 to 4000 tons 1 days production - ANS-2000 to 4000 tons Which is not typically used as an asphalt binder in fdot mix designs? PG 52-28 PG 58-22 PG 62-22 PG 76-22(PMA) PG 82-22 (PMA) - ANS-PG 62-22 Who cuts the density cores used for verification testing? The verification technician The contractor The independent verification testing technician None of the above - ANS-The contractor A full lot is composed of 5 sublots and 4 cores per lot T/F - ANS-False Given the target mix temperature of 290 degrees and the following truck temperatures 280, 285, 295, 300, 275.... No action is required, just document the results Reject the load exceeding the master range temperature target Check the next 5 loads to see if in tolerance and notify the plant - ANS-No action is required What is the most important for consistent compaction of asphalt mix? The mix is hotter in temperature The mix is colder in temperature The mix is uniform in temperature Temperature of the mix does not affect compaction - ANS-The mix is uniform in temperature Referring to general stationing guidelines, R1 would be ____ than R2 Closer to centerline Closer to outside shoulder Closure to the inside shoulder Both A and C - ANS-Both A and C While using the rolling straightedge, if the needle goes in the red zone indicating an unacceptable high spot in the section, you then - ANS-Mark the pavement where the needle first goes into the red zone and place another mark where the needle leaves the red zone and continue For bridge approach slabs, the 15 foot manual straightedge should be set so ____ is on the bridge deck. 1 inch Exactly 1/2 of the straightedge The entire straightedge None of the above - ANS-1 inch For the first transverse joint on a project place the ___ on the new pavement while overlapping the transverse joint by one inch. 4 foot level 15 foot manual straight edge Rolling straightedge All the above - ANS-15 foot manual straight edge When calibrating to check the low side of the rolling straight edge: Place shims under the outer wheels Place the rolling straight edge on a surface that looks flat Place a 3/16 inch shin under each outside wheel, the gauge should read zero on both sides of the gauge Place shims under the center wheel - ANS-Place a 3/16 inch shin under each outside wheel, the gauge should read zero on both sides of the gauge When calibrating to check the high side of the rolling straight edge: Place shims under the outer wheels Place shims under the center wheel Place the rolling straight edge on a surface that looks flat Place a 3/16 inch shin under the center wheel. The gauge should read zero on both sides of the gauge. - ANS-Place a 3/16 inch shim under the center wheel. The gauge should read zero on both sides of the gauge.