ADDA Mechanical Drafter Certification Practice - Part I Study Guide

EMILLYCHARLOTTE 2024/2025 ACADEMIC YAER ©2024 EMILLYCHARLOTTE. ALL RIGHTS RESERVED
FIRST PUBLISH SEPTEMBER 2024




ADDA Mechanical Drafter Certification
Practice - Part I Study Guide

orthographic - Answer✔✔-A multiview drawing is also known a(n) __________ drawing.


auxiliary - Answer✔✔-A(n) __________ view is projected from an inclined surface.


section - Answer✔✔-A(n) __________ view allows you to see the interior of an object.


removed - Answer✔✔-A(n) __________ section is usually not aligned with a the primary view.


offset - Answer✔✔-A(n) __________ section shows interior features not in a straight line by bending the

cutting plane line at 90° angles.


viewing plane line - Answer✔✔-The __________ indicates the position of a removed view and line of

sight.


cutting plane line - Answer✔✔-The line showing where an object is cut for a section and line of sight is

the __________.


size - Answer✔✔-An object can be made if its __________ and shape are fully-described.


shape - Answer✔✔-An object can be made if its size and __________ are fully-described.


bevel - Answer✔✔-A(n) __________ is a slanted surface along a straight edge.


chamfer - Answer✔✔-A(n) __________ is a slanted surface along a hole or the end of a cylinder.




Page 1/3