ASE A6 Electrical - Sample Quiz with Correct Answers

ASE A6 Electrical - Sample Quiz with Correct Answers 1. An alternator overrunning pulley (AOP) is being tested with the accessory drive belt removed. It is functioning correctly if________. A. The pulley rotates freely in only one direction B. The pulley is free to rotate in both directions C. The pulley is locked in both directions D. Either B or C - Ans:-A. The pulley rotates freely in only one direction 2. What type of problem is indicated by a lower than normal amperage reading when a circuit is activated? A. High resistance in the circuit B. An open ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 2/5 C. A short D. A blown fuse - Ans:-A. High resistance in the circuit 3. It has the word LEAST. For this question, look for the choice that would LEAST LIKELY cause the described situation. Read the entire question carefully before choosing your answer. An alternator has low output and is being full-fielded to determine the cause. Which of the following is the LEAST likely result of full-fielding the alternator? A. Battery gassing B. High alternator amperage output C. Low battery voltage level D. High battery voltage level - Ans:-C. Low battery voltage level 4. The cigar lighter requires repeated fuse replacements. The cause of this problem could be: A. a grounded wire between the lighter and the chassis. B. a shorted lighter element ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 3/5 C. a high resistance connector on the cigar lighter. D. high resistance in the lighter element. - Ans:-B. a shorted lighter element 5. A short in the ground may be identified by connecting a ______ in place of the circuit fuse. A. 12V test lamp B. multimeter C. fused jumper wire D. anmeter - Ans:-A. 12V test lamp 6. Which of the following reduces friction between a stationary and rotating part? A. A harness B. A bearing C. A brush D. A shunt - Ans:-B. A bearin