Automotive Collision ASE Practice Exam Practice Questions and Answers

Automotive Collision ASE Practice Exam Practice Questions and Answers Technician A says that when replacing metal parts, an anti-corosion material should be applied. Technician B says that some adhesive products may contain anti-corrosion properties. Who is right? A. A only B. B only C. Both A and B D, Neither A nor B - Ans:-C. Both A and B Technician A says that humidity can influence the rate of corrosion. Technician B says that cold temperatures can accelerate the rate of corrosion. Who is right? A. A only B. B only C. Both A and B ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 2/17 D. Neither A nor B - Ans:-A. A only Which of these is the best method to correct a filler weld with too little penetration? A. Increase the stick-out and increase the wire feed B. Increase the drive roll pressure and decrease the stick-out C. Decrease the drive speed and increase the heat and wire feed D. Increase the drive speed and decrease the stick-out - Ans:-A. increase the stick-out and increase the wire feed Which of these tools should be used to metal finish a damaged panel? A. Pick hammer and a vixen file B. A grater and in-line sander C. An electric sander with 16-grit sandpaper D. A stud pin welder - Ans:-B. A grater and in-line sander Which of these characteristics would be the most noticeable difference when metal finishing aluminum versus steel? A. Work hardening ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 3/17 B. Ambient temperature C. Location of damage D. Alloy composition - Ans:-D. Alloy composition When used to cut off a metal panel which of these tools would generate the least amount of heat? A. cut-off wheel B. Plasma cutting torch C. Air saw D. Oxyacetylene cutting torch - Ans:-A. Air saw Which of these products can be applied over the manufacturer's finish? A. Fiberglass fillers B. Aluminum fillers C. Polyester glazing putty D. talc fillers - Ans:-C. Polyester glazing putty Which of these methods of attachment would be used for composite panels? ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 4/17 A. Weld bonding B. Self-piercing rivets C. Panel bonding D. Lamination - Ans:-C. Panel bonding Direct damage and indirect damage are also known as: A. existing and pre-existing B. asymmetrical and symmetrical C. Literal and unilateral D. Primary and secondary - Ans:-B. asymmetrical and symmetrical The following question contains the word EXCEPT. Please read the question carefully and look for the choice that could NOT cause the described situation. A. cover the panel with welding blankets B. remove any parts that can be removed C. use shields to protect the panels ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 5/17 D. spray with water during the welding and cutting process - Ans:-D. spray with water during the welding and cutting process Technician A says that laminated glass may be used for the front windshield. Technician B says that tempered glass may be used for door glass. Who is right? A. A only B. B only C. Both A and B D. Neither A nor B - Ans:-C. Both A and B Which of these adjustments would be made if a door drops when it is opened? A. Move the lower hinge forward B. Move the upper hinge forward C. Move the striker upward D. Move the upper hinge rearward - Ans:-B. Move the up