©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
Chapter 64 ASE Questions 1-10 with
Correct Answers
Technician A says that it is normal for a small amount of moisture to be on the outside of a shock
absorber. Technician B says that if the outside of the shock absorber body has been damaged, replace it
along with the one on the other side of the car. Who is right? - Ans:✔✔-Both A and B.
Which of the following is/are true about shock absorber rubber mounts? - Ans:✔✔-When tightening a
nut on the top of a shock rod, the rod must be held from turning.
When replacing stabilizer link bushings, which of the following statements is/are true? - Ans:✔✔-Both A
and B.
Technician A says that a load-carrying ball joint must be unloaded to test it. Technician B says that a load-
carrying ball joint must be replaced if there is any perceptible movement. Who is right? - Ans:✔✔-
Technician A.
Which of the following is/are true statements? - Ans:✔✔-Both A and B.
When jacking against a control arm to compress a coil spring, the jack should be positioned: - Ans:✔✔-
Perpendicular (90 degrees) to the tires.
Page 1/2
FIRST PUBLISH OCTOBER 2024
Chapter 64 ASE Questions 1-10 with
Correct Answers
Technician A says that it is normal for a small amount of moisture to be on the outside of a shock
absorber. Technician B says that if the outside of the shock absorber body has been damaged, replace it
along with the one on the other side of the car. Who is right? - Ans:✔✔-Both A and B.
Which of the following is/are true about shock absorber rubber mounts? - Ans:✔✔-When tightening a
nut on the top of a shock rod, the rod must be held from turning.
When replacing stabilizer link bushings, which of the following statements is/are true? - Ans:✔✔-Both A
and B.
Technician A says that a load-carrying ball joint must be unloaded to test it. Technician B says that a load-
carrying ball joint must be replaced if there is any perceptible movement. Who is right? - Ans:✔✔-
Technician A.
Which of the following is/are true statements? - Ans:✔✔-Both A and B.
When jacking against a control arm to compress a coil spring, the jack should be positioned: - Ans:✔✔-
Perpendicular (90 degrees) to the tires.
Page 1/2