©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
T1 ASE Exam Questions and Answers
Which of the following is least likely to cause frame buckle?
Uneven weight distribution
Using the truck for a purpose other than its intended design
Fire
Collision - Ans:✔✔-Uneven weight distribution
Battery disconnect voltage is typically around how many volts?
10.4 volts
8.5 volts
12.2 volts
9.6 - Ans:✔✔-10.4 volts
Page 1/55
, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
A starter current draw test is being performed. Technician A says low current draw may be caused by
excessive resistance in the starter circuit. Technician B says high current draw may be caused by an
internal engine problem. Who is correct?
Both A and B
Technician A
Technician B
Neither A nor B - Ans:✔✔-Both A and B
The primary function of the EGR system is to reduce what?
NOx
CO
HC
CO2 - Ans:✔✔-NOx
Page 2/55
, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
A growling noise is heard when the A/C compressor is disengaged. Which of the following is the most
likely cause?
Loose clutch hub
Dry blower motor bearings
Worn compressor pulley bearing
Worn internal compressor bearings - Ans:✔✔-Worn compressor pulley bearing
The steering angle sensor must be calibrated in all of the following situations except:
When making repairs to the steering linkage
During wheel balance and rotation
When replacing the steering wheel
When performing a wheel alignment - Ans:✔✔-During wheel balance and rotation
Technician A says flat tappet lifters require a break-in period. Technician B says flat tappet lifters should
be checked for bleed-down using a special tool. Who is correct?
Page 3/55
, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
Technician A
Technician B
Both A and B
Neither A nor B - Ans:✔✔-Technician A
What color exhaust smoke indicates a potential internal coolant leak?
Blue
Gray
Black
White - Ans:✔✔-White
Most transmissions regulate pressure at approximately:
60 psi
Page 4/55
FIRST PUBLISH OCTOBER 2024
T1 ASE Exam Questions and Answers
Which of the following is least likely to cause frame buckle?
Uneven weight distribution
Using the truck for a purpose other than its intended design
Fire
Collision - Ans:✔✔-Uneven weight distribution
Battery disconnect voltage is typically around how many volts?
10.4 volts
8.5 volts
12.2 volts
9.6 - Ans:✔✔-10.4 volts
Page 1/55
, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
A starter current draw test is being performed. Technician A says low current draw may be caused by
excessive resistance in the starter circuit. Technician B says high current draw may be caused by an
internal engine problem. Who is correct?
Both A and B
Technician A
Technician B
Neither A nor B - Ans:✔✔-Both A and B
The primary function of the EGR system is to reduce what?
NOx
CO
HC
CO2 - Ans:✔✔-NOx
Page 2/55
, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
A growling noise is heard when the A/C compressor is disengaged. Which of the following is the most
likely cause?
Loose clutch hub
Dry blower motor bearings
Worn compressor pulley bearing
Worn internal compressor bearings - Ans:✔✔-Worn compressor pulley bearing
The steering angle sensor must be calibrated in all of the following situations except:
When making repairs to the steering linkage
During wheel balance and rotation
When replacing the steering wheel
When performing a wheel alignment - Ans:✔✔-During wheel balance and rotation
Technician A says flat tappet lifters require a break-in period. Technician B says flat tappet lifters should
be checked for bleed-down using a special tool. Who is correct?
Page 3/55
, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED
FIRST PUBLISH OCTOBER 2024
Technician A
Technician B
Both A and B
Neither A nor B - Ans:✔✔-Technician A
What color exhaust smoke indicates a potential internal coolant leak?
Blue
Gray
Black
White - Ans:✔✔-White
Most transmissions regulate pressure at approximately:
60 psi
Page 4/55
