NICET LEVEL 1 EXAM 2024 ACTUAL EXAM COMPLETE 400
QUESTIONS WITH DETAILED VERIFIED ANSWERS (100%
CORRECT ANSWERS) /ALREADY GRADED A+
what is the maximum number of 14 AWG RHH conductors which can be installed in
1/2 rigid metal conduit? - ANSWER: 4 wires
Which of the following would be an appropriate mounting height for a pull station? -
ANSWER: 3.5'-48" to the actuator
What is the minimum flash rate for a visible notification device? - ANSWER: 1 flash
per second
What is the minimum mounting height for audible notification devices? - ANSWER:
90" to the top of the device
What is the minimum mounting height for visible notification devices? - ANSWER:
Such that the entire lens is not less then 80"
What is the formula for Ohm's Law - ANSWER: Voltage=Current X Resistence
When using your mult-meter to measure, you must: - ANSWER: Put your meter in
series with the circuit
Waterflow devices shall be tested with that frequency? - ANSWER: Semi-annually
With what frequency shall ionization smoke detectors be given a functional test? -
ANSWER: Annually
What are the standby power requirements for a proprietary signaling system? -
ANSWER: 24 hours in normal operation, 5 minutes in alarm
Which of the following is a type of auxiliary protective signaling system? - ANSWER:
Shunt type
Remote station signaling systems are permitted to send signals to: - ANSWER: A UL
listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
Non-power limited fire alarm cable shall have an insulation rating of: - ANSWER:
600V
Which of these HVAC systems would require duct detectors on supply and return? -
ANSWER: 20,000 CFM HVAC system serving a single floor
, 15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
According to the IBC, which of the following use Groups require visual notification? -
ANSWER: Group A, E, F
Digital Alarm communicator transmitters (DACT) which use call forwarding to the
DACR shall be tested with what frequency? - ANSWER: Every 4 hours
When connecting 4 wires smoke detectors to a fire alarm system, the power
conductors shall be monitored for integrity. - ANSWER: True
Which of the following is true regarding smoke detector spacing? - ANSWER: Smoke
detectors shall be permitted to use 30 foot spacing as a guide
A slope ceiling is defined as: - ANSWER: A slope of greater than 1 in 8
Which of the following is true? - ANSWER: Fire alarm control equipment shall be
protected with an automatic detector when not in continuously occupied areas
Positive alarm sequence requires the approval of the AHJ
FPLP cable may be substituted with CMP cable
For sprinkler systems what type of signal is fire pump running? - ANSWER: Alarm
signal
Trouble signal
consider a fire alarm system with primary power source as commercial light power.
what type of branch circuit is permitted to supply the fire alarm system? - ANSWER:
A dedicated branch circuit
what is type of meter is typically used to measure current in a fire alarm system -
ANSWER: Multimeter
where an auxiliary fire alarm system uses a shunt loop, it shall not exceed a length of
_______feets. - ANSWER: 750 feets
software information and as built drawing shall be maintained for the life of the
system by which of the following? - ANSWER: Building Owner
what is the wire resistance in ohms of 500 feets of 16 awg solid copper which is
coated at 75 degrees C? - ANSWER: 2.54 ohms
which of the following concerns the use of pressure points in the body to help
control bleeding? - ANSWER: indirect pressure
QUESTIONS WITH DETAILED VERIFIED ANSWERS (100%
CORRECT ANSWERS) /ALREADY GRADED A+
what is the maximum number of 14 AWG RHH conductors which can be installed in
1/2 rigid metal conduit? - ANSWER: 4 wires
Which of the following would be an appropriate mounting height for a pull station? -
ANSWER: 3.5'-48" to the actuator
What is the minimum flash rate for a visible notification device? - ANSWER: 1 flash
per second
What is the minimum mounting height for audible notification devices? - ANSWER:
90" to the top of the device
What is the minimum mounting height for visible notification devices? - ANSWER:
Such that the entire lens is not less then 80"
What is the formula for Ohm's Law - ANSWER: Voltage=Current X Resistence
When using your mult-meter to measure, you must: - ANSWER: Put your meter in
series with the circuit
Waterflow devices shall be tested with that frequency? - ANSWER: Semi-annually
With what frequency shall ionization smoke detectors be given a functional test? -
ANSWER: Annually
What are the standby power requirements for a proprietary signaling system? -
ANSWER: 24 hours in normal operation, 5 minutes in alarm
Which of the following is a type of auxiliary protective signaling system? - ANSWER:
Shunt type
Remote station signaling systems are permitted to send signals to: - ANSWER: A UL
listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
Non-power limited fire alarm cable shall have an insulation rating of: - ANSWER:
600V
Which of these HVAC systems would require duct detectors on supply and return? -
ANSWER: 20,000 CFM HVAC system serving a single floor
, 15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
According to the IBC, which of the following use Groups require visual notification? -
ANSWER: Group A, E, F
Digital Alarm communicator transmitters (DACT) which use call forwarding to the
DACR shall be tested with what frequency? - ANSWER: Every 4 hours
When connecting 4 wires smoke detectors to a fire alarm system, the power
conductors shall be monitored for integrity. - ANSWER: True
Which of the following is true regarding smoke detector spacing? - ANSWER: Smoke
detectors shall be permitted to use 30 foot spacing as a guide
A slope ceiling is defined as: - ANSWER: A slope of greater than 1 in 8
Which of the following is true? - ANSWER: Fire alarm control equipment shall be
protected with an automatic detector when not in continuously occupied areas
Positive alarm sequence requires the approval of the AHJ
FPLP cable may be substituted with CMP cable
For sprinkler systems what type of signal is fire pump running? - ANSWER: Alarm
signal
Trouble signal
consider a fire alarm system with primary power source as commercial light power.
what type of branch circuit is permitted to supply the fire alarm system? - ANSWER:
A dedicated branch circuit
what is type of meter is typically used to measure current in a fire alarm system -
ANSWER: Multimeter
where an auxiliary fire alarm system uses a shunt loop, it shall not exceed a length of
_______feets. - ANSWER: 750 feets
software information and as built drawing shall be maintained for the life of the
system by which of the following? - ANSWER: Building Owner
what is the wire resistance in ohms of 500 feets of 16 awg solid copper which is
coated at 75 degrees C? - ANSWER: 2.54 ohms
which of the following concerns the use of pressure points in the body to help
control bleeding? - ANSWER: indirect pressure
