TEXAS STATE INSPECTION TEST EXAM ACTUAL EXAM
COMPLETE 200 QUESTIONS WITH DETAILED VERIFIED
ANSWERS (100% CORRECT ANSWERS) /ALREADY
GRADED A+
One of the required procedures in the inspection of the steering is... - ANSWER:
Turning the steering wheel from full left to full right
Conventional brakes or non-power brakes must have a minimum pedal reserve of... -
ANSWER: 2 inches
Any tire with wear bar indicators would be rejected for the following reason: -
ANSWER: Tread wear indicators contact the road on any two adjacent major grooves
in the center of the middle of the tire
LED tail lamps may have no more than ______ of the diodes malfunctioning to pass
inspection. - ANSWER: 50%
When performing the road test on the service brakes, a truck weighing over 10,000
lbs should be driven at the speed of 20 mph and should stop within ______ -
ANSWER: 40 feet
True/False: The vehicle owner/operator should be present when inspector is
checking CNG tank located in the trunk of the car - ANSWER: True
Glass coating or sun screening materials on windshields may not extend down past
the AS-1 line or more than ______ inches, whichever is closer to the top of the
windshield. - ANSWER: 5 inches
Brakes would be rejected if... - ANSWER: there is an obvious metal to metal contact
when brakes are applied
When issuing a Vehicle Inspection Report to a vehicle, the VIN will be taken from
the... - ANSWER: Vehicle
True/False: Proof of financial responsibility is not required on motor vehicles prior to
year model 1988 - ANSWER: False
When is a vehicle required to be inspected for seat belts? - ANSWER: Anchorages
were part of the manufacturer's original equipment
The turn signal selector switch must lock in the proper turn position when applied
on: - ANSWER: all vehicles
COMPLETE 200 QUESTIONS WITH DETAILED VERIFIED
ANSWERS (100% CORRECT ANSWERS) /ALREADY
GRADED A+
One of the required procedures in the inspection of the steering is... - ANSWER:
Turning the steering wheel from full left to full right
Conventional brakes or non-power brakes must have a minimum pedal reserve of... -
ANSWER: 2 inches
Any tire with wear bar indicators would be rejected for the following reason: -
ANSWER: Tread wear indicators contact the road on any two adjacent major grooves
in the center of the middle of the tire
LED tail lamps may have no more than ______ of the diodes malfunctioning to pass
inspection. - ANSWER: 50%
When performing the road test on the service brakes, a truck weighing over 10,000
lbs should be driven at the speed of 20 mph and should stop within ______ -
ANSWER: 40 feet
True/False: The vehicle owner/operator should be present when inspector is
checking CNG tank located in the trunk of the car - ANSWER: True
Glass coating or sun screening materials on windshields may not extend down past
the AS-1 line or more than ______ inches, whichever is closer to the top of the
windshield. - ANSWER: 5 inches
Brakes would be rejected if... - ANSWER: there is an obvious metal to metal contact
when brakes are applied
When issuing a Vehicle Inspection Report to a vehicle, the VIN will be taken from
the... - ANSWER: Vehicle
True/False: Proof of financial responsibility is not required on motor vehicles prior to
year model 1988 - ANSWER: False
When is a vehicle required to be inspected for seat belts? - ANSWER: Anchorages
were part of the manufacturer's original equipment
The turn signal selector switch must lock in the proper turn position when applied
on: - ANSWER: all vehicles
