BACKFLOW PREVENTION ASSEMBLY TESTER EXAM
NEWEST 2024 ACTUAL EXAM 2 VERSIONS (VERSION A
AND VERSION B) 270 QUESTIONS AND CORRECT
DETAILED ANSWERS (VERIFIED ANSWERS) |ALREADY
GRADED A+
In responding to a backflow incident the water purveyor should
(A) Call the mayor
(B) Implement the emergency response plan
(C) Install a vacuum breaker
(D) Develop a good excuse - ANSWER: Implement the emergency response plan
A mixture of air and gas is considered hazardous when the mixture exceeds what
percentage of gthe lower explosive limit
(A) 0%
(B) 3%
(C) 7%
(D) 10% - ANSWER: 10%
To exert a pressure of 1.0 psi at base of a water column the column would have to
be
(A) 4.34 high
(B) 14.7 high
(C) 27.75 high
(D) 33.89 high - ANSWER: 27.75 high
A DC must be tested
(A) Upon installation
(B) Every 6 month
(C) Annually on a health hazard
(D) none of the above - ANSWER: Upon installation
An absolute perssure of 25 psiaa (at sea level) is equal to approximately
(A) 5 psi
(B) 10 psi
(C) 20 psi
(D) 25 psi - ANSWER: 10 psi
Dueing a field test the air inlet on PVB must open at
,(A) Above 2.0 psid
(B) Below 1.0 psid
(C) Above 1.0 psid
(D) Below 2.0 psid - ANSWER: Above 1.0 psid
A differential pressuer gauge is used to field test
(A) PVB's
(B) Dual Checks
(C) AVB's
(D) All the above - ANSWER: PVB's
Backflow in a water supply can be caused by
(A) Backpressure only
(B) A Barometric Loop
(C) Backsiphonage only
(D) Backpressure and Backsiphonage - ANSWER: Backpressure and Backsiphonage
A BPAT tester is required to report test information on the proper forms to the
(A) Administrative authority
(B) Manufacturer's Rep
(C) EPA
(D) None of the above - ANSWER: Administrative authority
The relief valve opens when closing #2 shut off valve on a RP What is the most
probable cause
(A) #1 Shut off valve is open
(B) #2 Shut off valve is open
(C) #1 check is fouled open
(D) Shut off is leaking - ANSWER: #1 check is fouled open
When field testing the #1 Check of a RP the differential pressurw shouid be
(A) Greter than or equal to 5.0 psid
(B) 3.0 psid greater than the relief valve opening point
(C) 1.0 psid in the directiom of flow
(D) Less than 5.0 psid - ANSWER: Greter than or equal to 5.0 psid
When testing a SVB what is the firsrt test being performed
(A) The air inlet opening point
(B) The static pressure across the check valve
(C) To verify the #2shut off hold tight
, (D) To check if the SVB hold water - ANSWER: The static pressure across the check
valve
When testing a PVB the air inlet opens upon closing the #1 shut off valve What is the
most probable cause
(A) Leaking #2 shut off valve
(B) Leaking #1 shut off valve
(C) Fouied air inlert
(D) Fouied check valve - ANSWER: Leaking #2 shut off valve
A 2" AVB when used on irrigation systemsterm-15 shall be instilled
(A) 6" above all downstream piping
(B) 18" above all downstream piping
(C) 24" above all downstream piping
(D) 27 3/4" above all downstream piping - ANSWER: 6" above all downstream piping
What causes the relief valief valve to close on a RPZ?
(A) Reilef valve spring pressure
(B) Supply side water pressure
(C) Pressure differential between Check #1 and Check #2
(D) All the above - ANSWER: Supply side water pressure
When testing a RP instialled in vauil the relief valve opening point falls to zero What
is most probabie cause
(A) The relief valve is stuck shut
(B) #1 check is fouled
(C) the #2 shut off leaks by
(D) Installed improperly - ANSWER: Installed improperly
When field testing the DC the #1 check static differential pressure is found to be 0.0
psid What is the most probable cause
(A) Fouied #2 Check
(B) Leaking #2 shut off
(C) Fouled #1 check
(D) Leaking #1 shut off - ANSWER: Fouled #1 check
The critical level for checking the air inlet of the PVB is
(A) At the air inlet
(B) At #1 shut off
(C) At #1 test cock
(D) At #2 shut off - ANSWER: At the air inlet
NEWEST 2024 ACTUAL EXAM 2 VERSIONS (VERSION A
AND VERSION B) 270 QUESTIONS AND CORRECT
DETAILED ANSWERS (VERIFIED ANSWERS) |ALREADY
GRADED A+
In responding to a backflow incident the water purveyor should
(A) Call the mayor
(B) Implement the emergency response plan
(C) Install a vacuum breaker
(D) Develop a good excuse - ANSWER: Implement the emergency response plan
A mixture of air and gas is considered hazardous when the mixture exceeds what
percentage of gthe lower explosive limit
(A) 0%
(B) 3%
(C) 7%
(D) 10% - ANSWER: 10%
To exert a pressure of 1.0 psi at base of a water column the column would have to
be
(A) 4.34 high
(B) 14.7 high
(C) 27.75 high
(D) 33.89 high - ANSWER: 27.75 high
A DC must be tested
(A) Upon installation
(B) Every 6 month
(C) Annually on a health hazard
(D) none of the above - ANSWER: Upon installation
An absolute perssure of 25 psiaa (at sea level) is equal to approximately
(A) 5 psi
(B) 10 psi
(C) 20 psi
(D) 25 psi - ANSWER: 10 psi
Dueing a field test the air inlet on PVB must open at
,(A) Above 2.0 psid
(B) Below 1.0 psid
(C) Above 1.0 psid
(D) Below 2.0 psid - ANSWER: Above 1.0 psid
A differential pressuer gauge is used to field test
(A) PVB's
(B) Dual Checks
(C) AVB's
(D) All the above - ANSWER: PVB's
Backflow in a water supply can be caused by
(A) Backpressure only
(B) A Barometric Loop
(C) Backsiphonage only
(D) Backpressure and Backsiphonage - ANSWER: Backpressure and Backsiphonage
A BPAT tester is required to report test information on the proper forms to the
(A) Administrative authority
(B) Manufacturer's Rep
(C) EPA
(D) None of the above - ANSWER: Administrative authority
The relief valve opens when closing #2 shut off valve on a RP What is the most
probable cause
(A) #1 Shut off valve is open
(B) #2 Shut off valve is open
(C) #1 check is fouled open
(D) Shut off is leaking - ANSWER: #1 check is fouled open
When field testing the #1 Check of a RP the differential pressurw shouid be
(A) Greter than or equal to 5.0 psid
(B) 3.0 psid greater than the relief valve opening point
(C) 1.0 psid in the directiom of flow
(D) Less than 5.0 psid - ANSWER: Greter than or equal to 5.0 psid
When testing a SVB what is the firsrt test being performed
(A) The air inlet opening point
(B) The static pressure across the check valve
(C) To verify the #2shut off hold tight
, (D) To check if the SVB hold water - ANSWER: The static pressure across the check
valve
When testing a PVB the air inlet opens upon closing the #1 shut off valve What is the
most probable cause
(A) Leaking #2 shut off valve
(B) Leaking #1 shut off valve
(C) Fouied air inlert
(D) Fouied check valve - ANSWER: Leaking #2 shut off valve
A 2" AVB when used on irrigation systemsterm-15 shall be instilled
(A) 6" above all downstream piping
(B) 18" above all downstream piping
(C) 24" above all downstream piping
(D) 27 3/4" above all downstream piping - ANSWER: 6" above all downstream piping
What causes the relief valief valve to close on a RPZ?
(A) Reilef valve spring pressure
(B) Supply side water pressure
(C) Pressure differential between Check #1 and Check #2
(D) All the above - ANSWER: Supply side water pressure
When testing a RP instialled in vauil the relief valve opening point falls to zero What
is most probabie cause
(A) The relief valve is stuck shut
(B) #1 check is fouled
(C) the #2 shut off leaks by
(D) Installed improperly - ANSWER: Installed improperly
When field testing the DC the #1 check static differential pressure is found to be 0.0
psid What is the most probable cause
(A) Fouied #2 Check
(B) Leaking #2 shut off
(C) Fouled #1 check
(D) Leaking #1 shut off - ANSWER: Fouled #1 check
The critical level for checking the air inlet of the PVB is
(A) At the air inlet
(B) At #1 shut off
(C) At #1 test cock
(D) At #2 shut off - ANSWER: At the air inlet
