NICET Level 1 Fire Alarms (Latest 2024/ 2025 Update) Qs & As| 100% Correct| Grade A (Verified Answers)

NICET Level 1 Fire Alarms (Latest 2024/ 2025 Update) Qs & As| 100% Correct| Grade A (Verified Answers) Q: Which of the following conductor types is an acceptable substitute for FPLR? Answer: FPLP, CMP Q: Consider the use of PLFA fire alarm cable. The size of conductors in multiconductor cable shall not be smaller than____ AWG? Answer: 26 AWG Q: You are using a power tool that has a 3 prong (grounded) plug. The only outlets available are 2 prong (non grounded). What can be done? Answer: Locate a 3 prong plug or used a tool with a 2 prong plug. Q: The power source for a power limited fire alarm circuit shall be a listed PLFA or Class ____ transformer? Answer: Class 3 transformer Q: Which of the following is a symptom of heat stroke? Answer: Red skin, Elevated Body Temperature, Rapid, Weak pulse Q: The maximum number of 14 AWG, RHH conductors permitted in 1/2 inch EMT is ____? Answer: 4 Q: The distance between smoke detectors shall not exceed a nominal spacing of ____ feet? Answer: 30 feet Q: A portable ladder shall support at least ____ times the maximum intended load. Answer: 3.3 times Q: Consider smoke detector placement on a peaked ceiling. Detectors shall first be spaced and located within ___ feet. of the peak, measured horizontally? Answer: 3 feet Q: Ladders must be inspected____ to identify any visible defects that could cause employee injury? Answer: Before initial use Q: Consider heat detectors with listed spacing of 50 feet placed on a smooth and flat ceiling which is 10 feet AFF. Based on this ceiling height, the heat detectors shall have a spacing of ____ feet between devices? Answer: 50 feet Q: If a door release detector is specifically listed for door frame mounting, or if a listed combination or integral detector door closer assembly is used ____ detectors shall be required if installed according to the manufacturers published instructions? Answer: 1 detector Q: Intermediate Metal Conduit shall be securely fastened within ___ feet of each outlet box, junction box, device box, cabinet, conduit body, or other conduit termination? Answer: 3 feet Q: Consider a waterflow detection device. Activation of the initiating device shall occur within ____ seconds of waterflow at the initiating device when flow occurs which is equal to or greater than that from a single sprinkler with the smallest orifice size installed in the system? Answer: 90 seconds Q: The power source for a power limited fire alarm circuit shall be a listed PFLA or Class____ transformer? Answer: 3 transformer Q: Which of the following is an acceptable method for performing a smoke entry test of a spot type smoke detector? Answer: Listed and labeled smoke product acceptable to the manufacturer. Q: What are the general care instructions for injuries to muscle, bone and joints? Answer: Rest, Immortalize, Apply cold