NICET Level 1 Fire Alarm Systems
complete test exam (Latest
2024/ 2025 Qs & As| 100%
Correct| Grade A+ (Verified
Answers)
The operable part of a manually actuated alarm initiating device shall be not less
than inches AFF. CORRECT>>42 inches
Consider the use of grounding electrodes. Rod and pipe electrodes shall not be
less than feet in length? CORRECT>>8 feet
Smoke detectors should not be located in a direct airflow or closer than
inches from an air supply diffuser or return air opening? - Answer 36 inches
Consider the use of visible notification appliances. Wall mounted appliances shall
be mounted such that the entire lens is not less than inches above the
finished floor? CORRECT>>80 inches
How many 16 gauge conductors are permitted in a 4 x 1 1/2 inches square box?
CORRECT>>12
Wall mounted audible appliances shall have their tops above the finished floors at
heights of not less than inches and below the finished ceilings at distances of
not less than 6 inches? CORRECT>>90 inches
A minimum db ambient sound level with a 6 hour exposure time requires
hearing protection? CORRECT>>92 db
Spot type heat sensing fire detectors shall be located on the ceiling not less than
inches from the sidewall. CORRECT>>4 inches
While operating an aerial lift, the use of a body harnes and is not required?
CORRECT>>Stabilizer Hook, Grounding Pole, Insulation Mat
, Spot type smoke detectors shall be located on the ceiling or, if on a sidewall,
between the ceiling and inches down from the ceiling to the top of the
detector. CORRECT>>12 inches
The distance between spot type heat detectors shall not exceed their listed
spacing, and there shall be detectors within a distance of the listed spacing,
measured at right angles from the walls? CORRECT>>One Half
Where partitions extend to within percent of the ceiling height, the spaces
separated by the partitions shall be considered as separate rooms?
CORRECT>>15 percent
Consider 1,000 feet total of 18 gauge soild coated copper at 167o Fahrenheit. The
resistance of this conductor is ohm? CORRECT>>8.08 ohm
Consider the installation of heat detectors on a ceiling with beams. A ceiling shall
be treated as a smooth ceiling if the beams project no more than inches
below the ceiling? CORRECT>>4 inches
Which of the following conductor types is an acceptable substitute for FPLR?
CORRECT>>FPLP, CMP
Consider the use of PLFA fire alarm cable. The size of conductors in
multiconductor cable shall not be smaller than AWG? CORRECT>>26
AWG
You are using a power tool that has a 3 prong (grounded) plug. The only outlets
available are 2 prong (non grounded). What can be done? CORRECT>>Locate a 3
prong plug or used a tool with a 2 prong plug.
The power source for a power limited fire alarm circuit shall be a listed PLFA or
Class transformer? CORRECT>>Class 3 transformer
Which of the following is a symptom of heat stroke? CORRECT>>Red skin,
Elevated Body Temperature, Rapid, Weak pulse
The maximum number of 14 AWG, RHH conductors permitted in 1/2 inch EMT is
? CORRECT>>4
complete test exam (Latest
2024/ 2025 Qs & As| 100%
Correct| Grade A+ (Verified
Answers)
The operable part of a manually actuated alarm initiating device shall be not less
than inches AFF. CORRECT>>42 inches
Consider the use of grounding electrodes. Rod and pipe electrodes shall not be
less than feet in length? CORRECT>>8 feet
Smoke detectors should not be located in a direct airflow or closer than
inches from an air supply diffuser or return air opening? - Answer 36 inches
Consider the use of visible notification appliances. Wall mounted appliances shall
be mounted such that the entire lens is not less than inches above the
finished floor? CORRECT>>80 inches
How many 16 gauge conductors are permitted in a 4 x 1 1/2 inches square box?
CORRECT>>12
Wall mounted audible appliances shall have their tops above the finished floors at
heights of not less than inches and below the finished ceilings at distances of
not less than 6 inches? CORRECT>>90 inches
A minimum db ambient sound level with a 6 hour exposure time requires
hearing protection? CORRECT>>92 db
Spot type heat sensing fire detectors shall be located on the ceiling not less than
inches from the sidewall. CORRECT>>4 inches
While operating an aerial lift, the use of a body harnes and is not required?
CORRECT>>Stabilizer Hook, Grounding Pole, Insulation Mat
, Spot type smoke detectors shall be located on the ceiling or, if on a sidewall,
between the ceiling and inches down from the ceiling to the top of the
detector. CORRECT>>12 inches
The distance between spot type heat detectors shall not exceed their listed
spacing, and there shall be detectors within a distance of the listed spacing,
measured at right angles from the walls? CORRECT>>One Half
Where partitions extend to within percent of the ceiling height, the spaces
separated by the partitions shall be considered as separate rooms?
CORRECT>>15 percent
Consider 1,000 feet total of 18 gauge soild coated copper at 167o Fahrenheit. The
resistance of this conductor is ohm? CORRECT>>8.08 ohm
Consider the installation of heat detectors on a ceiling with beams. A ceiling shall
be treated as a smooth ceiling if the beams project no more than inches
below the ceiling? CORRECT>>4 inches
Which of the following conductor types is an acceptable substitute for FPLR?
CORRECT>>FPLP, CMP
Consider the use of PLFA fire alarm cable. The size of conductors in
multiconductor cable shall not be smaller than AWG? CORRECT>>26
AWG
You are using a power tool that has a 3 prong (grounded) plug. The only outlets
available are 2 prong (non grounded). What can be done? CORRECT>>Locate a 3
prong plug or used a tool with a 2 prong plug.
The power source for a power limited fire alarm circuit shall be a listed PLFA or
Class transformer? CORRECT>>Class 3 transformer
Which of the following is a symptom of heat stroke? CORRECT>>Red skin,
Elevated Body Temperature, Rapid, Weak pulse
The maximum number of 14 AWG, RHH conductors permitted in 1/2 inch EMT is
? CORRECT>>4
