Level 1 Module 7 Hand Bending Exam with questions and
all correct answers
One purpose of an offset bend is to _____. - CORRECT ANSWER ensure the conduit
enters straight into the junction box
The purpose of a saddle bend is to _____. - CORRECT ANSWER go around
obstructions
Which of the following describes circumference? - CORRECT ANSWER The distance
around a circle
A reamer is used to _____. - CORRECT ANSWER smooth the sharp inside edge of
metal conduit after it has been cut.
A right triangle is any triangle with _____. - CORRECT ANSWER one 90* angle
Which of the following should be used to cut conduit? - CORRECT ANSWER Hacksaw
A die is used to _____. - CORRECT ANSWER cut threads in conduit
Which of the following eliminates wrinkling or flattening when bending PVC? -
CORRECT ANSWER A plug set
The radius of a circle is defined as____. - CORRECT ANSWER the distance from the
center point to the edge of the circle
Which of the following is used to bend IMC? - CORRECT ANSWER A hickey
A damp sponge or cloth can be used to set bends in ____. - CORRECT ANSWER PVC
The formula pie x Distance is used to calculate _____. - CORRECT ANSWER
circumference
Two junction boxes are each located on different walls, 12 inches from the same corner.
Given a 90* bend with a take-up of 6 inches and a gain 2-1/4 inches, what is the
developed length of the conduit between them? - CORRECT ANSWER 21-3/4 inches
Two 90* bends in the same piece of conduit are required for a(n) _____. - CORRECT
ANSWER back-to-back bend
When creating an offset using 10* bends to cross a 6-inch obstruction, the distance
between bends is _______. - CORRECT ANSWER 36 inches
all correct answers
One purpose of an offset bend is to _____. - CORRECT ANSWER ensure the conduit
enters straight into the junction box
The purpose of a saddle bend is to _____. - CORRECT ANSWER go around
obstructions
Which of the following describes circumference? - CORRECT ANSWER The distance
around a circle
A reamer is used to _____. - CORRECT ANSWER smooth the sharp inside edge of
metal conduit after it has been cut.
A right triangle is any triangle with _____. - CORRECT ANSWER one 90* angle
Which of the following should be used to cut conduit? - CORRECT ANSWER Hacksaw
A die is used to _____. - CORRECT ANSWER cut threads in conduit
Which of the following eliminates wrinkling or flattening when bending PVC? -
CORRECT ANSWER A plug set
The radius of a circle is defined as____. - CORRECT ANSWER the distance from the
center point to the edge of the circle
Which of the following is used to bend IMC? - CORRECT ANSWER A hickey
A damp sponge or cloth can be used to set bends in ____. - CORRECT ANSWER PVC
The formula pie x Distance is used to calculate _____. - CORRECT ANSWER
circumference
Two junction boxes are each located on different walls, 12 inches from the same corner.
Given a 90* bend with a take-up of 6 inches and a gain 2-1/4 inches, what is the
developed length of the conduit between them? - CORRECT ANSWER 21-3/4 inches
Two 90* bends in the same piece of conduit are required for a(n) _____. - CORRECT
ANSWER back-to-back bend
When creating an offset using 10* bends to cross a 6-inch obstruction, the distance
between bends is _______. - CORRECT ANSWER 36 inches
