1
NCCCO OVERHEAD EXAM QUESTIONS AND ANSWERS 2025
When using a remote or radio control, it is important to?
✓ change battery at beginning of shift
Before using rigging, the operator should be aware of the?
✓ highest capacity rating
Overhead cranes should be parked in?
✓ an area where it will not cause an unsafe condition
What should you do when the hook or load is moving above personnel?
✓ sound a warning signal
Cranes shall not be used for side pulls unless?
✓ specifically authorized by a responsible person
1
,2
According to OSHA, power supply to the runway shall be controlled by?
✓ the switch or circuit breaker
ASME B30 standards are designed to?
✓ recommend safety
What is the ASME volume that pertains to overhead cranes?
✓ B30.2
The hoist limit switch which controls the upper limit of the load block.. (finish phrase)
✓ shall not be used as an operating control
According to OSHA, what type of chain should be used by an overhead crane?
✓ alloy
According to ASME B30.2, the removal criteria for regular lay wire rope is four broken wires in one
strand, in one lay or twelve randomly distributed broken..(finish phrase)
2
, 3
✓ wires in one lay
Which OSHA regulation listed below can you find information about hoisting slings?
a) 1910.184
b) 1910.550
c) 1910.180
d) 1910.601
✓ 1910.184
When given the signal (stop signal), what will the operator do?
✓ bridge travel
If the load does not balance after raising it off the floor, what steps should you take?
✓ lower to the floor and adjust the rigging
According to OSHA, frequent inspections are to be performed at what intervals?
✓ daily to monthly
If a crane is modified and re-rated it must be checked thoroughly by a?
3
NCCCO OVERHEAD EXAM QUESTIONS AND ANSWERS 2025
When using a remote or radio control, it is important to?
✓ change battery at beginning of shift
Before using rigging, the operator should be aware of the?
✓ highest capacity rating
Overhead cranes should be parked in?
✓ an area where it will not cause an unsafe condition
What should you do when the hook or load is moving above personnel?
✓ sound a warning signal
Cranes shall not be used for side pulls unless?
✓ specifically authorized by a responsible person
1
,2
According to OSHA, power supply to the runway shall be controlled by?
✓ the switch or circuit breaker
ASME B30 standards are designed to?
✓ recommend safety
What is the ASME volume that pertains to overhead cranes?
✓ B30.2
The hoist limit switch which controls the upper limit of the load block.. (finish phrase)
✓ shall not be used as an operating control
According to OSHA, what type of chain should be used by an overhead crane?
✓ alloy
According to ASME B30.2, the removal criteria for regular lay wire rope is four broken wires in one
strand, in one lay or twelve randomly distributed broken..(finish phrase)
2
, 3
✓ wires in one lay
Which OSHA regulation listed below can you find information about hoisting slings?
a) 1910.184
b) 1910.550
c) 1910.180
d) 1910.601
✓ 1910.184
When given the signal (stop signal), what will the operator do?
✓ bridge travel
If the load does not balance after raising it off the floor, what steps should you take?
✓ lower to the floor and adjust the rigging
According to OSHA, frequent inspections are to be performed at what intervals?
✓ daily to monthly
If a crane is modified and re-rated it must be checked thoroughly by a?
3
