FINAL EXAM AND PRACTICE QUESTIONS
EXAM 2024 ACTUAL EXAM COMPLETE
ACCURATE EXAM QUESTIONS WITH
DETAILED VERIFIED ANSWERS (100%
CORRECT ANSWERS) /ALREADY
GRADED A+
What are three main reasons to reject a vehicle from
performing an initial initial inspection ? -
....ANSWER...Excessive fluid leaks, engine
overheating, unsafe drive axle tire or wheel (dyno
test only)
While performing a visual inspection an inspector
observes there is no EGR amplifier even though one
is shown on the under hood emission label. The EGR
valve is connected to the ported vacuum. What EIS
analyzer entry should be made? -
....ANSWER...Missing
Which of the following actions should be taken if a
vehicles timing reads 5 degrees BTDC and the
,specification of the vehicle is 8 degrees ? -
....ANSWER...Enter "PASS" into the analyzer for
ignition timing and 5 degrees BTDC for the timing
reading
Which of the following is a primary purpose of the
smog check referee ? - ....ANSWER...Perform
inspection dispute resolutions
What action should be taken when a 23 month old
car with 22,000 miles on its odometer fails an
emissions inspection because of a failed emission
component? - ....ANSWER...Refer the customer to go
to a dealer for the repair
What is the difference between a three wire oxygen
sensor and a single wire oxygen sensor ? -
....ANSWER...A three wire allows earlier closed loop
operation
are smog check inspections and or repairs allowed
to be sublet - ....ANSWER...No but there are a few
exceptions
,Is sales tax included on the estimate? -
....ANSWER...No only on the invoice
Functional tests are procedures that consist of -
....ANSWER...EGR systems, ignition timing, MIL, OBD,
LPFET, fuel cap (following manufacturer procedures,
smog check manual and as prompted by the
inspection system
Under functional which two tests does gasoline
powered vehicles from 96 to 99 require? -
....ANSWER...OBD AND MIL
What are the two required tests do gasoline
powered vehicles from 75 to 95 require? -
....ANSWER...Tailpipe and Visual and everything
comes with it
On government vehicles if the odometer is missing
or illegible enter ___? - ....ANSWER...None; N/A
Inspect a dual/ bi-fuel vehicle using the ⛽️ -
....ANSWER...Fuel in which the vehicle was operating
on when it arrived to the station
, The ASM emission inspection includes two loaded
mode sequences known as ___/___ and ___/____? -
....ANSWER...50/15 and 25/25
If the BAR referee label is missing what should the
technician inform the customer ?? - ....ANSWER...To
contact the bar referee for inspection information
An SPCN, grey market or vehicle with an engine
change without a bar referee label it must be first
inspected where ? - ....ANSWER...Referee
If no liquid leak is found what should you input into
the EIS OR OIS? - ....ANSWER...Pass
If a liquid fuel leak is detected what should you input
into the EIS OR OIS? - ....ANSWER..."F" for fail ,
defective
If a vehicle is equipped with parts that modify the
original emission control configuration, inspectors
must verify if those parts are exempted or ? -
....ANSWER...Carb approved