CNC NIMS Exam Questions And
Answers Latest Update
If you want to move a tool from Right to Left toward the workpiece,
what direction do you crank the handle or move the axis? -
correct answer ✅Negative (-)
Match the following codes with the corresponding letters.___M30 -
correct answer ✅Program end/ rewing
A boxed dimension is defined as a_______. -
correct answer ✅Basic
As an CNC operator in a machining lab, when should you wear
safety Glasses? -
correct answer ✅As you enter the manufacturing environment
What Mode switch position allows you to move the machine axes
manually? -
correct answer ✅Jog
Line N29 (facing in X) -
correct answer ✅X0
, CNC NIMS Exam Questions And
Answers Latest Update
If you are standing in front of a CNC Turning Center slant bed, what
direction does the Z axis travel. -
correct answer ✅Up and down (in and out)
Line N14 (Arc, Pos 4-5) -
correct answer ✅G02 X-.063 Z.250 R-.125
You are boring a hole with a boring bar and the hole has a +.001
tolerance. Since you don't want to machine it out of tolerance on
the first part and scrap it, you might go to the Tool offset and
temporarily alter it. What direction would you go in X? -
correct answer ✅subtract -.002
You are boring a hole and the depth has a +.0005 tolerance. Since
you don't want to machine it out of tolerance on the first part and
scrap it, you might go to the Tool offset and temporarily alter it.
What direction would you move in Z the tool offset? -
correct answer ✅Subtract -.002
You must cut a block 3.125 inches long and add 1/8 of an inch for
finish machining. The length of the block you must cut is ... -
correct answer ✅3.250
Answers Latest Update
If you want to move a tool from Right to Left toward the workpiece,
what direction do you crank the handle or move the axis? -
correct answer ✅Negative (-)
Match the following codes with the corresponding letters.___M30 -
correct answer ✅Program end/ rewing
A boxed dimension is defined as a_______. -
correct answer ✅Basic
As an CNC operator in a machining lab, when should you wear
safety Glasses? -
correct answer ✅As you enter the manufacturing environment
What Mode switch position allows you to move the machine axes
manually? -
correct answer ✅Jog
Line N29 (facing in X) -
correct answer ✅X0
, CNC NIMS Exam Questions And
Answers Latest Update
If you are standing in front of a CNC Turning Center slant bed, what
direction does the Z axis travel. -
correct answer ✅Up and down (in and out)
Line N14 (Arc, Pos 4-5) -
correct answer ✅G02 X-.063 Z.250 R-.125
You are boring a hole with a boring bar and the hole has a +.001
tolerance. Since you don't want to machine it out of tolerance on
the first part and scrap it, you might go to the Tool offset and
temporarily alter it. What direction would you go in X? -
correct answer ✅subtract -.002
You are boring a hole and the depth has a +.0005 tolerance. Since
you don't want to machine it out of tolerance on the first part and
scrap it, you might go to the Tool offset and temporarily alter it.
What direction would you move in Z the tool offset? -
correct answer ✅Subtract -.002
You must cut a block 3.125 inches long and add 1/8 of an inch for
finish machining. The length of the block you must cut is ... -
correct answer ✅3.250
