NCCER ELECTRICAL 2 MODULE 9 COMPLETE
QUESTIONS AND CORRECT ANSWERS | GRADED
AND THE LATEST SERIES
A ground fault is described as
Ans: an unintentional electrically conducting connection between an ungrounded
conductor of an electrical circuit and a normally non current carrying conductor
Question: Where a main bonding jumper is required by NEC, the main
bonding jumper cannot be less than what percentage
Ans: 12.5%
Question: A ground test utilizing an auxiliary electrode and an auxiliary
potential electrode is known as
Ans: 3 point test
Question: If single gain nail on non metallic boxes are used with NM cable
which of the following is true, plastic box dont have to
Ans: Ground it no connection to the box is required
Question: The fall of potential method is used to measure what
Ans: Earths resistance
Question: Rod, pipe, and plate electrodes must have a reistance to ground of
at least
, 2025-2026 SERIES
Ans: 25ohms
Question: In a separately derived system the equipment bonding jumper
connects to the
Ans: system housing to the Neutral bus bar
Question: Which type of system is required to be grounded
Ans: AC system over 1kv that supplies mobile or portable equipment
Question: The size of an EGC Equipment Grounding Conductor is determined
by what
Ans: Size of Overcurrent protection device (Breaker)
Question: Which of the following is true when installing grounding at more
than one building?
Ans: The grounded circuit conductor and equipment grounding conductor must
both be extended to the second building
Question: A transformer supplied system operating at less than 50v must be
grounded is the supplied voltage to the transformer exceeds
Ans: 150v
Question: To be effective, a grounding system must limit the voltage on the
electrical system and protect it from