Modules 1 - 4 Switching Concepts, VLANs, and
InterVLAN Routing Exam New
Which two tasks can be performed by using the command history feature?
Set the command history buffer size.
Recall previous commands that have been entered.
When a switch is powered on, what is the first step in the boot sequence?
load a power-on self-test program
What does an administrator need to do to reset a lost password on a router?
physical access to the router
When configuring a switch for SSH access, what other command that is associated with
the login local command must be entered on the switch?
username username secret secret
,Which of the following commands displays the auto-MDIX setting for an interface?
show controllers
If one end of an Ethernet connection is configured for full duplex and the other end of
the connection is configured for half duplex, where would late collisions occur?
on the half-duplex end of the connection
Which command is used to set the BOOT environment variable that identifies where to
find the IOS image file on a switch?
boot system
What does a switch use to locate and load the IOS?
BOOT environment variable
Which protocol adds security to remote connections?
SSH
, What is a characteristic of an IPv4 loopback interface on a Cisco IOS router?
It is a logical interface internal to the router.
What is the minimum Ethernet frame size that will not be discarded by the receiver as a
runt frame?
64 bytes
We have an expert-written solution to this problem!
After which step of the switch bootup sequence is the boot loader executed?
after POST execution
Which effect does the addition of a Layer 2 switch have on a network?
the size of the broadcast domain is increased
Which characteristic is true of cut-through switching?
Frames are forwarded without checking for errors.
What is the major difference between a hub and a Layer 2 LAN switch?
A hub extends the collision domain whereas a switch segments the collision domains.
InterVLAN Routing Exam New
Which two tasks can be performed by using the command history feature?
Set the command history buffer size.
Recall previous commands that have been entered.
When a switch is powered on, what is the first step in the boot sequence?
load a power-on self-test program
What does an administrator need to do to reset a lost password on a router?
physical access to the router
When configuring a switch for SSH access, what other command that is associated with
the login local command must be entered on the switch?
username username secret secret
,Which of the following commands displays the auto-MDIX setting for an interface?
show controllers
If one end of an Ethernet connection is configured for full duplex and the other end of
the connection is configured for half duplex, where would late collisions occur?
on the half-duplex end of the connection
Which command is used to set the BOOT environment variable that identifies where to
find the IOS image file on a switch?
boot system
What does a switch use to locate and load the IOS?
BOOT environment variable
Which protocol adds security to remote connections?
SSH
, What is a characteristic of an IPv4 loopback interface on a Cisco IOS router?
It is a logical interface internal to the router.
What is the minimum Ethernet frame size that will not be discarded by the receiver as a
runt frame?
64 bytes
We have an expert-written solution to this problem!
After which step of the switch bootup sequence is the boot loader executed?
after POST execution
Which effect does the addition of a Layer 2 switch have on a network?
the size of the broadcast domain is increased
Which characteristic is true of cut-through switching?
Frames are forwarded without checking for errors.
What is the major difference between a hub and a Layer 2 LAN switch?
A hub extends the collision domain whereas a switch segments the collision domains.
