NIMS 2 Packet
brush - ANS- The safest way to remove chips from a lathe or milling machine is to use a:
Run out on work holding devices - ANS- Small chips left on the spindle nose of the lathe
should be cleaned to avoid
Zero fittings on machine tools - ANS- Grease guns are used to insert grease into
Use a lubricant found in central lubricating systems ("one shots") - ANS- To lubricate the
ways of the lathe, the gibs of a mill, or the cross slide of a grinder
tighten the taper gib adjustment - ANS- If a vertical mill is loose and has side play, the
best solution to alleviate the side play is to
Preventative maintenance schedule and machine manual - ANS- Machinist wants to find
the proper type of lubrication, schedule and best recommended maintenance practices
for the headstock of a lathe. The best source to find this information is
In a general maintenance manual - ANS- General maintenance information for machine
tools and machine work area can be found
Pinning refers to - ANS- Loading the file with metal chips
Files should be stored - ANS- In a toolbox separated from each other
The best way to clean the chips out of a file is to use a - ANS- File card
What is the most common injury that may occur during a file operation - ANS- Being
stabbed with the tang
The best lubricant to prevent wear and increase cutting efficiency for tapping common
steels is - ANS- Sulfur-based oil
The process plan specifies tooling to be used by indicating - ANS- Tooling diameters
and sizes
A reaming operation produces finish tears. The cause of the tears is: - ANS- A reamer
with a worn tip
brush - ANS- The safest way to remove chips from a lathe or milling machine is to use a:
Run out on work holding devices - ANS- Small chips left on the spindle nose of the lathe
should be cleaned to avoid
Zero fittings on machine tools - ANS- Grease guns are used to insert grease into
Use a lubricant found in central lubricating systems ("one shots") - ANS- To lubricate the
ways of the lathe, the gibs of a mill, or the cross slide of a grinder
tighten the taper gib adjustment - ANS- If a vertical mill is loose and has side play, the
best solution to alleviate the side play is to
Preventative maintenance schedule and machine manual - ANS- Machinist wants to find
the proper type of lubrication, schedule and best recommended maintenance practices
for the headstock of a lathe. The best source to find this information is
In a general maintenance manual - ANS- General maintenance information for machine
tools and machine work area can be found
Pinning refers to - ANS- Loading the file with metal chips
Files should be stored - ANS- In a toolbox separated from each other
The best way to clean the chips out of a file is to use a - ANS- File card
What is the most common injury that may occur during a file operation - ANS- Being
stabbed with the tang
The best lubricant to prevent wear and increase cutting efficiency for tapping common
steels is - ANS- Sulfur-based oil
The process plan specifies tooling to be used by indicating - ANS- Tooling diameters
and sizes
A reaming operation produces finish tears. The cause of the tears is: - ANS- A reamer
with a worn tip
