©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:32AM. A+
Michigan ASE Brake Certification Exam
Questions With Correct Answers 100%
Verified.
Air in Hydraulic System - Answer✔A spongy brake pedal may be caused by
Excessive tire pressure - Answer✔Can not cause very erratic brake pulling while applying brakes
Excessive brake pedal travel - Answer✔A power assist brake booster push rod that is too short
will cause
Brake drum machined beyond its limits - Answer✔Can cause brake pedal fade
Repair leak and replace brake linings - Answer✔How to correctly service brake linings soaked
with axle grease but still have a lot of lining left on them
Metering Valve - Answer✔Disc/Drum system, the front brakes lock up on light pedal
application. This could be caused by a bad:
Seized caliper piston - Answer✔Will NOT cause a low brake pedal
Air in the hydraulic system - Answer✔A spongy brake pedal on a vehicle with 4-wheel disc
brakes with a lower than normal travel indicates
Movement of brake pad during braking - Answer✔Causes disc brake squeal
Incorrect master cylinder pushrod adjustment - Answer✔Excessive pedal travel before brakes
apply is caused by
Properly operating - Answer✔Power brakes that move down slightly when the engine is started
with the brakes applied are
Vacuum supply test - Answer✔Checks the vacuum supply hose for kinks and checks the level of
vacuum supplied by the engine or vacuum pump
1
Michigan ASE Brake Certification Exam
Questions With Correct Answers 100%
Verified.
Air in Hydraulic System - Answer✔A spongy brake pedal may be caused by
Excessive tire pressure - Answer✔Can not cause very erratic brake pulling while applying brakes
Excessive brake pedal travel - Answer✔A power assist brake booster push rod that is too short
will cause
Brake drum machined beyond its limits - Answer✔Can cause brake pedal fade
Repair leak and replace brake linings - Answer✔How to correctly service brake linings soaked
with axle grease but still have a lot of lining left on them
Metering Valve - Answer✔Disc/Drum system, the front brakes lock up on light pedal
application. This could be caused by a bad:
Seized caliper piston - Answer✔Will NOT cause a low brake pedal
Air in the hydraulic system - Answer✔A spongy brake pedal on a vehicle with 4-wheel disc
brakes with a lower than normal travel indicates
Movement of brake pad during braking - Answer✔Causes disc brake squeal
Incorrect master cylinder pushrod adjustment - Answer✔Excessive pedal travel before brakes
apply is caused by
Properly operating - Answer✔Power brakes that move down slightly when the engine is started
with the brakes applied are
Vacuum supply test - Answer✔Checks the vacuum supply hose for kinks and checks the level of
vacuum supplied by the engine or vacuum pump
1
