E1 RESIDENTIAL ELECTRICAL INSPECTOR EXAM TEST BANK EXAM LATEST VERSION ALL WITH 350 QUESTIONS AND CORRECT DETAILED ANSWERS JUST RELEASED THIS YEAR

Page 1 of 67




E1 RESIDENTIAL ELECTRICAL INSPECTOR
EXAM TEST BANK EXAM LATEST VERSION
ALL WITH 350 QUESTIONS AND CORRECT
DETAILED ANSWERS JUST RELEASED THIS
YEAR


Question: When a rod used as a grounding electrode is buried in a trench, what must the
minimum depth of the trench be? - CORRECT ANSWER✔✔30 Inches




Section E3608.1.4.1




Question: A supplemental grounding electrode is not required when the single grounding
electrode provided has a resistance of ___ ohms or less to the earth. - CORRECT ANSWER✔✔25




Section E3608.4 Exception




Question: A minimum unit load of ___ volt-amperes shall be used to size feeder conductors for
lighting and general use receptacle loads per square foot of floor area. - CORRECT ANSWER✔✔3

, Page 2 of 67


Section E3704.4




Question: What is the minimum demand load factor in volt-amperes for an electrical clothes
dryer circuit when calculating to determine the minimum electrical feeder loads? - CORRECT
ANSWER✔✔5,000 VA




Table E3704.2(1)




Question: True or False. The calculated load of a feeder shall not be less than the sum of the
loads on the supplied branch circuits before any applicable demand factors have been applied. -
CORRECT ANSWER✔✔False




Section E3704.5 - After




Question: Branch circuits are permitted to be rated for ___ amps when supplying lighting units
or other utilization equipment. - CORRECT ANSWER✔✔Both 15 or 20




Section E3702.3




Question: No. 14 copper conductors are permitted to have a maximum overcurrent protection
device rating of many amps? - CORRECT ANSWER✔✔15 amps

, Page 3 of 67




Table E3705.5.3




Question: Which of the following is considered to be a standard ampere rating for fuses?
25amps, 55amps, 75amps, 95amps - CORRECT ANSWER✔✔25amps




Section E3705.6




Question: What is the minimum size a circuit conductor is required to be when a branch circuit
having two or more outlets is rated at 20 amps? - CORRECT ANSWER✔✔12 AWG




Table E3702.14




Question: Fixed utilization equipment shall be supplied with a minimum ___-ampere branch
circuit. - CORRECT ANSWER✔✔30




Section E3702.4




Question: True or False. An electric space heating and water heating appliance shall be
considered as a continuous loads. - CORRECT ANSWER✔✔True

, Page 4 of 67




Section E3702.10




Question: Lighting units are permitted to be supplied with either a ___-ampere or ___-ampere
branch circuit. - CORRECT ANSWER✔✔15,20




Section E3702.3




Question: The ampacity of branch circuit conductors shall not be less than ___ percent of the
motors full-load current rating when supplying a single motor. - CORRECT ANSWER✔✔125




Section E3702.6




Question: Receptacle outlets located in laundry areas shall be provided with a minimum of
_____ branch circuit(s). - CORRECT ANSWER✔✔One 20-ampere-rated




Section E3703.3




Electrical devices operating at less than ___ volts and not supplying more than ___ watts of
energy shall be exempt from requiring an electrical permit. - CORRECT ANSWER✔✔25,50