NICET Level 1 Fire Alarm Systems complete test exam . Questions with 100% correct and verified answers. A+ GRADED.

NICET Level 1 Fire Alarm Systems complete test exam . Questions with 100% correct and verified answers. A+ GRADED. The operable part of a manually actuated alarm initiating device shall be not less than inches AFF. CORRECT42 inches Consider the use of grounding electrodes. Rod and pipe electrodes shall not be less than feet in length? CORRECT8 feet While operating an aerial lift, the use of a body harnes and CORRECTStabilizer Hook, Grounding Pole, Insulation Mat is not required? Smoke detectors should not be located in a direct airflow or closer than inches from an air supply diffuser or return air opening? - Answer 36 inches Consider the use of visible notification appliances. Wall mounted appliances shall be mounted such that the entire lens is not less than inches above the finished floor? CORRECT80 inches How many 16 gauge conductors are permitted in a 4 x 1 1/2 inches square box? CORRECT12 Wall mounted audible appliances shall have their tops above the finished floors at heights of not less than inches and below the finished ceilings at distances of not less than 6 inches? CORRECT90 inches A minimum db ambient sound level with a 6 hour exposure time requires hearing protection? CORRECT92 db Spot type heat sensing fire detectors shall be located on the ceiling not less than inches from the sidewall. CORRECT4 inches Spot type smoke detectors shall be located on the ceiling or, if on a sidewall, between the ceiling and inches down from the ceiling to the top of the detector. CORRECT12 inches The distance between spot type heat detectors shall not exceed their listed spacing, and there shall be detectors within a distance of the listed spacing, measured at right angles from the walls? CORRECTOne Half Where partitions extend to within percent of the ceiling height, the spaces separated by the partitions shall be considered as separate rooms? CORRECT15 percent Consider 1,000 feet total of 18 gauge soild coated copper at 167o Fahrenheit. The resistance of this conductor is ohm? CORRECT8.08 ohm Consider the installation of heat detectors on a ceiling with beams. A ceiling shall be treated as a smooth ceiling if the beams project no more than inches below the ceiling? CORRECT4 inches Which of the following conductor types is an acceptable substitute for FPLR? CORRECTFPLP, CMP Consider the use of PLFA fire alarm cable. The size of conductors in multiconductor cable shall not be smaller than AWG? CORRECT26 AWG You are using a power tool that has a 3 prong (grounded) plug. The only outlets available are 2 prong (non grounded). What can be done? CORRECTLocate a 3 prong plug or used a tool with a 2 prong plug. The power source for a power limited fire alarm circuit shall be a listed PLFA or Class transformer? CORRECTClass 3 transformer Which of the following is a symptom of heat stroke? CORRECTRed skin, Elevated Body Temperature, Rapid, Weak pulse The maximum number of 14 AWG, RHH conductors permitted in 1/2 inch EMT is ? CORRECT4 The distance between smoke detectors shall not exceed a nominal spacing of feet? CORRECT30 feet A portable ladder shall support at least CORRECT3.3 times times the maximum intended load. Consider smoke detector placement on a peaked ceiling. Detectors shall first be spaced and located within feet. of the peak, measured horizontally? CORRECT3 feet