1|Page
MWS CCRE EXAM WITH CORRECT ACTUAL
QUESTIONS AND CORRECTLY WELL DEFINED
ANSWERS LATEST 2024 – 2025 ALREADY GRADED A+
The purpose of the priming device test is to: - (answers)Evaluate how quickly the
priming device can create a vacuum to bring water through a pumpto the
discharge hose.
Identify TWO items that should be included on daily MWS apparatus records. -
(answers)Coolant levels
Traveling at high speeds on a curvy road may cause an MWS apparatus to: -
(answers)Leave the road surface and roll over.
Identify the THREE steps for changing to the left lane on a limited access highway.
- (answers)1. Check the side and rear view mirrors.
2. Activate the turn signal.
3. Move the apparatus safely to the left lane.
Identify the FOUR steps for passing through a straight section of a road or
highway. - (answers)1. Maintain apparatus speed.
2. Check the side streets or roads.
3. Check the side and rear view mirrors.
4. Check for oncoming traffic.
, 2|Page
When performing the serpentine exercise, you: - (answers)Should only travel in
one direction, without striking the obstruction.
All of the following statements about driving an MWS apparatus through areas of
restricted horizontal and vertical clearances are true EXCEPT: - (answers)Use the
appropriate turn signal.
The best type of strainer to use in a shallow stream is a: - (answers)Floating
strainer.
NFPA rates all fire pumps to meet their capacity from a draft at: - (answers)10
feet of lift.
Which equation is used to determine the elevation pressure loss for resupplying a
pumper located approximately 20 feet above the location of the MWS? -
(answers)EP = 0.5x20
The best definition of water pressure is the: - (answers)Force of water per unit
area.
All of the following factors must be included when determining the total pressure
loss (TPL) EXCEPT: - (answers)Pump pressure loss
The hand method can be used for estimating the friction loss in a hoseline with a
diameter of: - (answers)2 1/2 inches
MWS CCRE EXAM WITH CORRECT ACTUAL
QUESTIONS AND CORRECTLY WELL DEFINED
ANSWERS LATEST 2024 – 2025 ALREADY GRADED A+
The purpose of the priming device test is to: - (answers)Evaluate how quickly the
priming device can create a vacuum to bring water through a pumpto the
discharge hose.
Identify TWO items that should be included on daily MWS apparatus records. -
(answers)Coolant levels
Traveling at high speeds on a curvy road may cause an MWS apparatus to: -
(answers)Leave the road surface and roll over.
Identify the THREE steps for changing to the left lane on a limited access highway.
- (answers)1. Check the side and rear view mirrors.
2. Activate the turn signal.
3. Move the apparatus safely to the left lane.
Identify the FOUR steps for passing through a straight section of a road or
highway. - (answers)1. Maintain apparatus speed.
2. Check the side streets or roads.
3. Check the side and rear view mirrors.
4. Check for oncoming traffic.
, 2|Page
When performing the serpentine exercise, you: - (answers)Should only travel in
one direction, without striking the obstruction.
All of the following statements about driving an MWS apparatus through areas of
restricted horizontal and vertical clearances are true EXCEPT: - (answers)Use the
appropriate turn signal.
The best type of strainer to use in a shallow stream is a: - (answers)Floating
strainer.
NFPA rates all fire pumps to meet their capacity from a draft at: - (answers)10
feet of lift.
Which equation is used to determine the elevation pressure loss for resupplying a
pumper located approximately 20 feet above the location of the MWS? -
(answers)EP = 0.5x20
The best definition of water pressure is the: - (answers)Force of water per unit
area.
All of the following factors must be included when determining the total pressure
loss (TPL) EXCEPT: - (answers)Pump pressure loss
The hand method can be used for estimating the friction loss in a hoseline with a
diameter of: - (answers)2 1/2 inches
