Respiratory Critical Care -ACCS exam
Questions and Verified Answers (100%
Correct Answers) /Already Graded A+
Bodai adapter
Ans: A device that fits on the endotracheal tube for bronchoscopy
The endotracheal tube must be at least a size ____ for bronchoscopy?
By Prep Pass 2025/2026 Series
Ans: 7.0 mm
Amount of force needed for cricoid pressure?
Approved
Ans: 10-30 Newtons
Sledinger approach
Ans: When a bougie is inserted through the old endotracheal tube, which is
removed, and the new endotracheal tube is advanced over the wire.
Inhaled nitric oxide dosage
Ans: 20-40 ppm
The best starting dosage for nitric oxide
Ans: 40 ppm
Helium - oxygen mixture is helpful in treating what?
Ans: Severe asthma, ARDS, COPD, and pulses paradoxes.
Heli ox mixtures should be given through what device?
Ans: Non-rebreather
Tidal volume range for ARDS
Ans: 4-6 mL/kg
, Page |2
Respiratory rate for ARDS
Ans: 12-24 per minute
PF Ratio less than 200
Ans: ARDS
PF ratio less than 300
Ans: ALI
By Prep Pass 2025/2026 Series
High frequency initial vent settings: start with frequency of what?
Ans: 4-8 Hz
Approved
High frequency initial vent settings: start I - time percent at what?
Ans: 33%
High frequency initial vent settings: bias flow set at what?
Ans: 40 L/minute
APRV initial setting for P - high
Ans: Set at plateau pressure
APRV initial setting for T - high
Ans: 4.5-6.0 seconds
APRV initial setting for P - low
Ans: 0-3 cm H2O
APRV initial setting for T - low
Ans: 0.5-0.8 seconds
Proportional assist ventilation (PAV)