OSHA30 EXAM QUESTIONS AND ANSWERS WITH COMPLETE SOLUTIONS VERIFIED GRADED A++

OSHA30 EXAM QUESTIONS AND ANSWERS WITH COMPLETE SOLUTIONS VERIFIED GRADED A++ Terms in this set (243) During steel assembly, shear connectors will be installed metal decking is in place: after During steel assembly, the total weight of a bundle of decking should not exceed 4,000 lbs. T/F true During steel assembly, shear Connectors should not be attached to the top flanges of beams or joists. T/F true During steel assembly, the employer shall ensure that the weight of a bundle of joist bridging shall not exceed a total of: 1,000 lbs When placing solid web members for beams/columns, diagonal bracing may be secured with at least one bolt per connection, wrench-tight. T/F true Subpart R contains numerous references to Tables A and B. These tables refer to erection bridging requirements associated with short and long span joists, and can be found in: Within the standard Subpart R When placing solid web members for beams/columns, the load shall not be released until the members are secured with at least two bolts per connection. T/F true Columns must be equipped with vertical stabilizer plates all of the above Connectors working at heights over 15 and up to 30 feet must tie off with: at least one of the above Deckers in a Controlled Decking Zone must be protected at heights greater than: 2 stories Safety nets must be installed no more than 30 feet below the walking/working surface whenever: all of the above Which of the following is true of a CDZ: all of the above Training must be each of the following EXCEPT: sporadic Training must include: all of the above Training must include procedures for erecting, maintaining, disassembling, and inspecting fall protection systems. T/F true Work from water towers and tanks is exempt from the Steel Erection Standard. T/F true Perimeter safety cables of 1/2 inch wire rope must be installed: both a & b When there is no overhead protection, the must ensure that personnel are not working below steel erection: controlling contractor The weight of a bundle of joist bridging shall not exceed a total of 1,000 pounds. T/F true A pre-work shift visual of cranes must be performed by: a competent person During steel assembly, the bundle of decking is placed on a minimum of ______ joists: 3 Connectors working at heights over 15 and up to 30 feet must tie off with: at least one of the above OSHA requires that all equipment left unattended at night, adjacent to a highway in normal use, must have: A or B