2024- ACTUAL EXAM WITH A STUDY GUIDE AND PRACTICE EXAM |
GUARANTEED PASS | LATEST UPDATE
A Customer whose vehicle has failed the Smog Check inspection has
been approved for a repair cost waiver. How long is the duration of
the repair cost waiver? - CORRECT ANSWER Two years or 2 years
Technician A says that all vehicles with fuel evaporation from 1976 to
1995 are subject to the LPFET functional test. Technician B says that
only vehicles older than 1996 receiving a TSI test are subject to the
functional EGR test. Who's correct? - CORRECT ANSWER Both
Technicians
The OBD II functional test evaluates and reports the status of all the
following, except? - CORRECT ANSWER Mode 6 Pending Codes
While conducting a functional test on an EGR valve, the technician
increases RPM and can see the valve Pinole move up. Based on that
information, how would the technician enter this condition into the
emission inspection system (EIS)?
Pass
N/A
Defective
None of the above - CORRECT ANSWER NONE OF THE ABOVE
Two technicians are discussing the procedures for performing the
ignition timing functional test. Technician A states that if no
manufacturer engine speed tolerance is given, the idle speed should
be within 100 RPM of manufacturers specified idle speed. Technician
B states that if the procedures for timing check are nit found in the
under hood label the inspector must refer to the emission control
,application guide or the manufacturer service Manual. Who's correct?
- CORRECT ANSWER Both technicians
A smog technician is conducting an ASM smog test on a vehicle with a
standard transmission (stick). The engine size is 3.6L. What gear
should the technician first try to conduct the test and what RPM
should he keep the engine within while conducting the test? -
CORRECT ANSWER 2nd gear with the RPM between 1250 and 2500
How often must you calibrate the BAR-97 EIS? - CORRECT ANSWER
Every 72 hours or when prompted NOT AND PROMPTED OR
The emission inspection system (EIS) shows a dilution error on the
screen. What is the EIS seeing at this time? - CORRECT ANSWER High
O2
The TAC (Thermostatic Air Control) helps heath the incoming air to
the induction system. This control is accomplished by a vacuum
operated blend door in the air cleaner snorkel. When the nine is not
running (0° manifold vacuum), in what position is the blend door? -
CORRECT ANSWER The "Hot air mode"
Technician A states that Exhaust Gas Recirculation is a post-
combustion emission component. Technician B States that the
Exhaust Gas Recirculation is a pre-combustion emission component.
Who is correct? - CORRECT ANSWER Technician B
Technician A States that the MIL illuminates when emissions are
inferred to be 1.5 times the federal test procedures standards.
Technician B states the MIL may only be used fo emission failures.
Who is correct? - CORRECT ANSWER Both technicians
,Which of the following inspection procedures is performed with the
engine running?
Fuel Cap Pressure Test
Liquid Fuel Leaks Check
Oil Level Check
Visual Inspection - CORRECT ANSWER Liquid fuel leaked check
During an OIS inspection on a 2000MY or newer vehicle, what would
be the correct procedure to follow if the customer did not bring the
registration paperwork for the smog Check inspection? - CORRECT
ANSWER Scan the Barcode on the vehicle itself
The Smog inspector has entered all the data into the EIS. The EIS
contacts the VID and it returns a message "No Match" how should the
inspector proceed with this smog check? - CORRECT ANSWER Verify
the VIN and Plate number match the numbers on the DMV
paperwork, if so, complete the smog check inspection
Technician A states that inspectors are not required to perform
disassembly of the vehicle to inspect for liquid fuel leaks. Technician B
states the liquid fuel leak visual inspection does not apply to diesel
vehicles. Who's correct? - CORRECT ANSWER Both technicians
If licenses say CA exempt or have a letter E in the beginning then they
are government fleet vehicles true or false - CORRECT ANSWER True
During the visual inspection the technician notices that the vehicle has
a non OEM aftermarket carburetor installed. What is the correct
procedure to inspect the vehicle - CORRECT ANSWER Check to see if
the carburetor is approved as a street legal replacement part
, A vehicle is undergoing a Smog check inspection. The under-hood BAR
referee emissions label lists an ECS that is not in the vehicle. How
should the technician handle this situation - CORRECT ANSWER List
the system as missing in the EIS machine
A smog technician has scanned the DMV registration document. The
VIN number of the vehicle does not match the VIN number on the
DMV paperwork. What must the technician do? - CORRECT ANSWER
Run the smog check using the VIN number on the vehicle and note the
VIN discrepancy on the paper work.
A 2001MY vehicle comes in for a smog inspection. Upon visual
inspection the inspector notices that the vehicle is equipped with a
biodiesel kit. Technician A states that the inspector must check the
part for an ARB EO exemption. Technician B states EO exemptions for
biodiesel kits only apply to vehicles 2004MY and newer Who is
Correct? - CORRECT ANSWER Technician B
The Three-Way Catalytic Converter Helped reduce what emission not
previously controlled by the oxidizing converter - CORRECT ANSWER
NOx
Other than the biennial Smog check, when does a vehicle require
being tested in an enhanced area - CORRECT ANSWER Transfer of
ownership and Initial registration in the state of California
A smog check sign must be posted at all smog check stations What is
the required size for this sign - CORRECT ANSWER 24" by 30"
Which of the following is NOT required to be visibly posted in an area
frequented by customers - CORRECT ANSWER The Sales Tax that is
charged for certificates