Safety Certification EXAM|complete study guide with detailed questions and 100% verified answers|Already graded A

The first step to a job safety analysis is to: A. Prepare a list of potential problems b. document an itemized sequence of job tasks c. Identify the hazard of each task d. propose potential solutions to problems - correct answer️️Document an itemized sequence of job tasks What does NIOSH stand for? a. National Institute for Occupational Safety and Health b. National Institute for Organizations Safety and Health c. Nationwide Instructions for Occupational Safety and Health d. Nationwide Instructions for Organizational Safety and Health - correct answer️️National Institute for Occupational Safety and Health An employee questions the quality of the materials inside a trailer and pages his/her supervisor to come to the trailer. It is clear that the contents have been seriously damaged in shipment. Which of the following actions is appropriate? a. Reject the load to the carrier b. Call the inbound planner to come count the contents of the shipment c. Only accept the undamaged portions d. Accept the load and take it to the line for use - correct answer️️Reject the load to the carrier Several federal agencies enforce regulations concerning the workplace. The federal agency concerned with enforcement of safety regulations is: a. EPA b. OSHA c. DOT d. NIOSH - correct answer️️OSHA Which of the following is NOT a requirement of a fixed ladder a. The length of the rung has to be 16" b. The distance between rungs shall exceed 16" c. Cages are required on all fixed ladders over 20" d. When required, landing platforms must be a minimum of 24" x 30" - correct answer️️The distance between rungs shall exceed 16" Audits of environmental or quality systems within an organization typically include all of the following except: a. Detailed instructions on how to improve the system b. A list of operational metrics that will be used to track performance c. Timelines for corrective actions to be taken d. Individuals who are responsible for implementing the corrective action - correct answer️️Detailed instructions on how to improve the system A job safety analysis should NOT be conducted by? a. A maintenance worker b. An operator c. A project engineer d. An OSHA representative - correct answer️️An OSHA representative The risk of injury for new employees is ___ than for those with experience a. Less Likely b. More likely c. About the same d. Exactly the same - correct answer️️More Likely In most manufacturing plants, the chance of being exposed to blood-borne pathogens is relatively small. In these plants, the greatest risk of exposure is: a. Working with a respirator b. Contact with bodily fluid while working with first aid c. Exposure to certain pesticides and toxic metals d. Getting cut on a sharp surface - correct answer️️Contact with bodily fluid while working with first aid To make sure the receiver has understood a message, you should: a. Ask them if they understood what you said b. Make them sign a statement that they understood c. Have the recipient rephrase what was said in his/her own words d. None of the above - correct answer️️Have the recipient rephrase what was said in their own words The primary need for training in today's manufacturing environment is: a. Job justification/documentation b. Change in people/processes c. To receive government money d. To involve employees - correct answer️️Change in people/processes What color code is commonly used to indicate areas where radiation is present? a. Blue on red b. Green on white c. Yellow on green d. Black on Yellow - correct answer️️Black on yellow Noise induced hearing loss first effects the ability to hear: a. High frequency sounds b. Low frequency sounds c. All sounds d. Inaudible tones - correct answer️️High Frequency sounds