NICET LEVEL 1 / NICET LEVEL 2 & NICET LEVEL 3 /
STUDY GUIDE QUESTIONS (2017 NEWEST
COMPILATION REVIEW) COMPREHENSIVE STUDY
GUIDE – EXPERT STRATEGIES, REVIEW OF KEY QUIZZES,
AND PRACTICE QUESTIONS FOR GUARANTEED
SUCCESS / NEWEST 2025/2026
what is the maximum number of 14 AWG RHH conductors which can be
installed in 1/2 rigid metal conduit? - answer-4 wires
Which of the following would be an appropriate mounting height for a pull
station? - answer-3.5'-48" to the actuator
What is the minimum flash rate for a visible notification device? - answer-1
flash per second
which of the following concerns the use of pressure points in the body to help
control bleeding? - answer-indirect pressure
Each EMT run between termination points shall be securely fastened within
_______feets of each outlet box, junction box, device box ,cabinet , conduit
body, or other tubing termination ? - answer-3 feets
two way shall be tele capable of permitting the simultaneous operation of any
______telephone stationsin a commun talked mode - answer-5 telephones
, what is the wire resistance in ohms, of 1000 feet of 14 AWG solid copper which
is coated at 75 degrees C? - answer-3.19 ohm
a trouble signal shall be indicated and recorded with____seconds? - answer-
200 seconds
What type of auxiliary fire alarm system does not permit the use of automatic
detectors? - answer-Shunt
A steam pressure supervisory shall indicate a low pressure condition .The off
normal signal be initiated prior to the pressure falling below _____% of the
minimum operating equipment supplied? - answer-110 %
What is the minimum mounting height for audible notification devices? -
answer-90" to the top of the device
What is the minimum mounting height for visible notification devices? -
answer-Such that the entire lens is not less then 80"
What is the formula for Ohm's Law - answer-Voltage=Current X Resistence
STUDY GUIDE QUESTIONS (2017 NEWEST
COMPILATION REVIEW) COMPREHENSIVE STUDY
GUIDE – EXPERT STRATEGIES, REVIEW OF KEY QUIZZES,
AND PRACTICE QUESTIONS FOR GUARANTEED
SUCCESS / NEWEST 2025/2026
what is the maximum number of 14 AWG RHH conductors which can be
installed in 1/2 rigid metal conduit? - answer-4 wires
Which of the following would be an appropriate mounting height for a pull
station? - answer-3.5'-48" to the actuator
What is the minimum flash rate for a visible notification device? - answer-1
flash per second
which of the following concerns the use of pressure points in the body to help
control bleeding? - answer-indirect pressure
Each EMT run between termination points shall be securely fastened within
_______feets of each outlet box, junction box, device box ,cabinet , conduit
body, or other tubing termination ? - answer-3 feets
two way shall be tele capable of permitting the simultaneous operation of any
______telephone stationsin a commun talked mode - answer-5 telephones
, what is the wire resistance in ohms, of 1000 feet of 14 AWG solid copper which
is coated at 75 degrees C? - answer-3.19 ohm
a trouble signal shall be indicated and recorded with____seconds? - answer-
200 seconds
What type of auxiliary fire alarm system does not permit the use of automatic
detectors? - answer-Shunt
A steam pressure supervisory shall indicate a low pressure condition .The off
normal signal be initiated prior to the pressure falling below _____% of the
minimum operating equipment supplied? - answer-110 %
What is the minimum mounting height for audible notification devices? -
answer-90" to the top of the device
What is the minimum mounting height for visible notification devices? -
answer-Such that the entire lens is not less then 80"
What is the formula for Ohm's Law - answer-Voltage=Current X Resistence
