Page | 1
PA APPRAISERS LICENSE EXAM 2025| BRAND
NEW ACTUAL EXAM WITH 100% VERIFIED
QUESTIONS AND CORRECT SOLUTIONS|
GUARANTEED VALUE PACK| ACE YOUR
GRADES.
1. In order to be eligible for an auto appraiser license, which of the
following is NOT a requirement? - correct answer - To have been
previously employed by an auto manufacturer is correct.
2. How is a diamond condition fixed? - correct answer - By pulling the
damage for length. Diamond is a length condition.
3. When measuring a unibody vehicle, it is discovered that the left front
rail is 111mm from spec in width. What condition is this? - correct
answer - Width is calculated from the center out, so a value of -111mm
on the left rail shows sway to the right and in toward centerline.
4. A collision damaged vehicle is discovered to be down in height at
opposite end of the center section. - correct answer - Twist condition.
5. When diagnosing the damage to a full frame assembly on a sport utility
vehicle, it is determined that the left side frame rail is higher than the
right side frame rail. Technician A says the damaged state is known as
a twist condition. Technician B says a sway condition exists. Who is
right? - correct answer - Tech A. When a frame rail's relationship to the
vehicle centerline is changed, such as pushed either to the left or right,
the condition is known as sway. "Twist" is referred as the condition of
, Page | 2
the frame when entire sections are driven higher or lower than the
opposite side.
, Page | 3
6. Metal fillers contain different ingredients that provide fillers with special
properties. - correct answer - Fiberglass offers more resistance to
moisture
7. HSLA - correct answer - High Strength Low Alloy
8. When replacing the floor pan in the trunk area, what joint should be
used to join the new pan to the existing floor? - correct answer - An
overlap joint
9. When acoustical foam is removed during the repair: - correct answer
- It must be replaced with acoustical foam.
10. When setting up a three-dimensional measuring system, it should be
setup on an undamaged area. - correct answer - Starting in the center
section is the correct method.
11. What is the plastic Black box in rear of the car? - correct answer -
Vapor Canister
12. Grinding or squeaking from wheel is a sign of what? - correct answer
- Bad Bearings
, Page | 4
13. The insurance commissioner is responsible for everything except? -
correct answer - Endorsing an insurance company
14. How do you tell when a ball joint is bad? - correct answer - Measure
fixed points from knuckle to rotor
15. What makes the windows go up and down? - correct answer -
Window regulator
16. What panel needs to get removed is there is damage to the quarter
panel? - correct answer - The taillight
17. Actuator - correct answer - Tells something to do something
18. Sensor - correct answer - Take reading and tell when something is
wrong
19. What is Urethane Paint? - correct answer - Better than acrylic,
extremely durable, and resists chipping; easier to apply
PA APPRAISERS LICENSE EXAM 2025| BRAND
NEW ACTUAL EXAM WITH 100% VERIFIED
QUESTIONS AND CORRECT SOLUTIONS|
GUARANTEED VALUE PACK| ACE YOUR
GRADES.
1. In order to be eligible for an auto appraiser license, which of the
following is NOT a requirement? - correct answer - To have been
previously employed by an auto manufacturer is correct.
2. How is a diamond condition fixed? - correct answer - By pulling the
damage for length. Diamond is a length condition.
3. When measuring a unibody vehicle, it is discovered that the left front
rail is 111mm from spec in width. What condition is this? - correct
answer - Width is calculated from the center out, so a value of -111mm
on the left rail shows sway to the right and in toward centerline.
4. A collision damaged vehicle is discovered to be down in height at
opposite end of the center section. - correct answer - Twist condition.
5. When diagnosing the damage to a full frame assembly on a sport utility
vehicle, it is determined that the left side frame rail is higher than the
right side frame rail. Technician A says the damaged state is known as
a twist condition. Technician B says a sway condition exists. Who is
right? - correct answer - Tech A. When a frame rail's relationship to the
vehicle centerline is changed, such as pushed either to the left or right,
the condition is known as sway. "Twist" is referred as the condition of
, Page | 2
the frame when entire sections are driven higher or lower than the
opposite side.
, Page | 3
6. Metal fillers contain different ingredients that provide fillers with special
properties. - correct answer - Fiberglass offers more resistance to
moisture
7. HSLA - correct answer - High Strength Low Alloy
8. When replacing the floor pan in the trunk area, what joint should be
used to join the new pan to the existing floor? - correct answer - An
overlap joint
9. When acoustical foam is removed during the repair: - correct answer
- It must be replaced with acoustical foam.
10. When setting up a three-dimensional measuring system, it should be
setup on an undamaged area. - correct answer - Starting in the center
section is the correct method.
11. What is the plastic Black box in rear of the car? - correct answer -
Vapor Canister
12. Grinding or squeaking from wheel is a sign of what? - correct answer
- Bad Bearings
, Page | 4
13. The insurance commissioner is responsible for everything except? -
correct answer - Endorsing an insurance company
14. How do you tell when a ball joint is bad? - correct answer - Measure
fixed points from knuckle to rotor
15. What makes the windows go up and down? - correct answer -
Window regulator
16. What panel needs to get removed is there is damage to the quarter
panel? - correct answer - The taillight
17. Actuator - correct answer - Tells something to do something
18. Sensor - correct answer - Take reading and tell when something is
wrong
19. What is Urethane Paint? - correct answer - Better than acrylic,
extremely durable, and resists chipping; easier to apply
