DIESEL TECH SUSPENSION AND
STEERING ASE TEST 3 (PRACTICE ASE
TEST 3) LATEST QUESTIONS WITH
COMPLETE ANSWERS!!
1 of 43
Term
Technician A says air spring suspensions use shock absorbers to help
maintain axle alignment. Technician B says that shock absorbers are used to
control spring oscillations. Who is correct?
A. only
B only
Both A and B
Neither A nor B
Give this one a try later!
, C. Both A and B A. A only
B. B only D. A preloaded axle wheel bearing
Don't know?
2 of 43
Term
A technician finds an irregular wear pattern on a tire that is
overinflated. Which wear pattern did the technician find on the tire?
A. Outside edges of the tire
B.Center of the tire
C. Cupping pattern
D.Inside edges of the tire
Give this one a try later!
B. B only C. Both A and B
A. Loose spring shackles B. Center of the tire
Don't know?
3 of 43
Term
,Two technicians are discussing the replacement procedure for a
power steering pump pulley. Technician A states that if there is a
retaining nut on the shaft, the pulley is retained by a woodruff key to
prevent pulley rotation on the shaft. Technician B says that it is
acceptable to use a soft-faced hammer and to tap on the ump shaft
to remove the pulley. Who is correct?
A. A only
B.B only
C. Both A and B
D.Neither A nor B
Give this one a try later!
A. A only D. Excessive tire wear exists
C. Both A and B B. B only
Don't know?
4 of 43
Term
When draining a power steering system, all of the following should
be done EXCEPT:
A. Drain the fluid by removing the return hose at the
remote reservoir fitting
B.With the engine stopped, turn the steering wheel fully in
each direction
C. When the clean fluid begins to discharge from the return hose,
shut the engine off
, D.Perform a final :bleed on the system once the return hose
is reinstalled
Give this one a try later!
C. It must have the same yield B. With the engine stopped,
strength as the original frame turn the steering wheel fully in
each direction
D. Reverse the shims from left D. Reverse one shim to correct for
to right to correct for a twisted a twisted axle
axle
Don't know?
5 of 43
Term
When adjusting caster, all of the following statements are true
EXCEPT:
A. Use only one shim on each side
B. The width of the shim should equal the width of the spring
C. Do not use shims of more than 1 degree difference from side
to side
D.Reverse the shims from left to right to correct for a twisted axle
Give this one a try later!
STEERING ASE TEST 3 (PRACTICE ASE
TEST 3) LATEST QUESTIONS WITH
COMPLETE ANSWERS!!
1 of 43
Term
Technician A says air spring suspensions use shock absorbers to help
maintain axle alignment. Technician B says that shock absorbers are used to
control spring oscillations. Who is correct?
A. only
B only
Both A and B
Neither A nor B
Give this one a try later!
, C. Both A and B A. A only
B. B only D. A preloaded axle wheel bearing
Don't know?
2 of 43
Term
A technician finds an irregular wear pattern on a tire that is
overinflated. Which wear pattern did the technician find on the tire?
A. Outside edges of the tire
B.Center of the tire
C. Cupping pattern
D.Inside edges of the tire
Give this one a try later!
B. B only C. Both A and B
A. Loose spring shackles B. Center of the tire
Don't know?
3 of 43
Term
,Two technicians are discussing the replacement procedure for a
power steering pump pulley. Technician A states that if there is a
retaining nut on the shaft, the pulley is retained by a woodruff key to
prevent pulley rotation on the shaft. Technician B says that it is
acceptable to use a soft-faced hammer and to tap on the ump shaft
to remove the pulley. Who is correct?
A. A only
B.B only
C. Both A and B
D.Neither A nor B
Give this one a try later!
A. A only D. Excessive tire wear exists
C. Both A and B B. B only
Don't know?
4 of 43
Term
When draining a power steering system, all of the following should
be done EXCEPT:
A. Drain the fluid by removing the return hose at the
remote reservoir fitting
B.With the engine stopped, turn the steering wheel fully in
each direction
C. When the clean fluid begins to discharge from the return hose,
shut the engine off
, D.Perform a final :bleed on the system once the return hose
is reinstalled
Give this one a try later!
C. It must have the same yield B. With the engine stopped,
strength as the original frame turn the steering wheel fully in
each direction
D. Reverse the shims from left D. Reverse one shim to correct for
to right to correct for a twisted a twisted axle
axle
Don't know?
5 of 43
Term
When adjusting caster, all of the following statements are true
EXCEPT:
A. Use only one shim on each side
B. The width of the shim should equal the width of the spring
C. Do not use shims of more than 1 degree difference from side
to side
D.Reverse the shims from left to right to correct for a twisted axle
Give this one a try later!
