Science Engineering Mechanical Engineering
NCCER Electrical Level 2 Module 2 Motors:
Theory and Application Sections 4-6
Save
Students also studied
Flashcard sets Study guides
Module 26202-20 Exam Motors: The... 2023 lvl2. module 2 quiz AWF2 RATE EXAM
30 terms 57 terms Teacher 197 terms
jackwilliams5703 Preview vlad_vidi Preview boa9nsore
The two primary types of motor open and totally enclosed
enclosures classified by NEMA
are ____.
An open AC squirrel cage motor sealed windings(type)
that makes use ofform-wound
coils and an insulation system is
known asa(n) _____.
The NEMA frame designation for G
gasoline pump motors is ____.
The letters FLA on a motor full-load amps
nameplate stand for ____.
To determine the horsepower check the nameplate data
rating of a motor that is already
installed and in place, ____.
Most industrial motors are B
NEMA Design ____.
The multiplier to the nameplate service factor
horsepower rating is called the
_____.
The code requirements for 430.102
motor disconnects are covered
in ___.
All motors must have a thermal 600V-1,000V
protector if their voltage rating
is greater than_____.
To protect the motor from thermal protector
overloads and starting failures,
use a ____.
NCCER Electrical Level 2 Module 2 Motors:
Theory and Application Sections 4-6
Save
Students also studied
Flashcard sets Study guides
Module 26202-20 Exam Motors: The... 2023 lvl2. module 2 quiz AWF2 RATE EXAM
30 terms 57 terms Teacher 197 terms
jackwilliams5703 Preview vlad_vidi Preview boa9nsore
The two primary types of motor open and totally enclosed
enclosures classified by NEMA
are ____.
An open AC squirrel cage motor sealed windings(type)
that makes use ofform-wound
coils and an insulation system is
known asa(n) _____.
The NEMA frame designation for G
gasoline pump motors is ____.
The letters FLA on a motor full-load amps
nameplate stand for ____.
To determine the horsepower check the nameplate data
rating of a motor that is already
installed and in place, ____.
Most industrial motors are B
NEMA Design ____.
The multiplier to the nameplate service factor
horsepower rating is called the
_____.
The code requirements for 430.102
motor disconnects are covered
in ___.
All motors must have a thermal 600V-1,000V
protector if their voltage rating
is greater than_____.
To protect the motor from thermal protector
overloads and starting failures,
use a ____.
