TCFP Driver/Operator Exam with Verified
Answers Rated to Pass
Which of the following is the correct order of operations for performance testing? -
✅✅ The weight verification test, the braking system test, the parking brake test,
and the road test
Before beginning any performance tests on fire apparatus pumps, all of the
following environmental conditions must be determined and recorded prior to and
immediately after the pump performance testing except: - ✅✅ humidity
When performing a vacuum test, the vacuum inside a pump or suction hose should
not drop in excess of ________________ in __________ minutes. - ✅✅ 10 in; 5
In a pressure control test, the pressure control device should be tested at intervals
of 150 psi, 90 psi, and: - ✅✅ 250 psi
How often should pump tests be performed - ✅✅ Annually
What term refers to a device that allows the bypass of fluids to limit the pressure in
a system? - ✅✅ Relief valve
Which type of test is basically a test of the priming system, specifically the
tightness of the pump, including its valves and fittings. - ✅✅ Vacuum
,When backing a fire apparatus, the driver/ operator should always use a
_________________ if available. - ✅✅ spotter
A 360-degree inspection refers to a(n): - ✅✅ Complete walk- around inspection
of the unit before you go on a response
A warning alarm must activate when pressure in the air system falls below: - ✅✅
60 psi (414 kpa)
What is the normal operating pressure for an air braking system on most fire
apparatus? - ✅✅ 100-120 psi
While driving a fire apparatus around an emergency scene, the driver/ operator
may be forced to maneuver the fire apparatus in a tight area and around obstacles
that are hanging down, such as trees or building signs. NFPA 1002 requires the
driver/ operator to successfully complete a ________________ exercise to
stimulate this challenge. - ✅✅ Diminishing clearance
While responding to an emergency, the driver/ operator may accidentally pass an
intended turn, forcing him or her to turn around. NFPA 1002 requires the driver/
operator to successfully complete a ____________________exercise to simulate
this challenge. - ✅✅ Confined space turnaround
Which of the following delivers operational power to the fire apparatus chassis? -
✅✅ Ignition switch
Which NFPA standard requires the driver/ operator of a fire apparatus NOT move
the apparatus until all persons on the vehicle are seated and secured with seat belts
in approved riding positions? - ✅✅ NFPA 1500
,True or False? If the fire apparatus is equipped with rear mounted camera, it can
take the place of an actual spotter. - ✅✅ False
Which NFPA standard requires that all seats on a fire apparatus be enclosed and
provided with an approved seat belt? - ✅✅ NFPA 1901
If the fire apparatus engine does not start within 30 seconds after the starter has
been engaged release the starter switch and allow the starter motor to cool for
__________________ before attempting to start it again. - ✅✅ 2 minutes
Every fire department should have an SOP that covers fire apparatus backing
procedures who needs to be trained and held accountable for these procedures? -
✅✅ Every member of the Fire Dept.
For most fire departments, the largest number of fire apparatus accidents is related
to: - ✅✅ Backing the apparatus
In accordance with NFPA 1901, a fire apparatus wiht a completely discharged air
system must be able to move within _________________ of start up. - ✅✅ 1
minute
In 1720 what was the piece of equipment to replace the bucket brigade? - ✅✅
Hand Pump
Which NFPA standard required new fire apparatus to be designed so that all
members riding on the fire apparatus would be provided a seated area inside an
enclosed cab? - ✅✅ NFPA 1500
, What was the first gasoline powered fire apparatus to discharge water by using a
large soda acid extinguisher? - ✅✅ Chemical Wagon
The real breakthrough for today's modern fire apparatus came with the introduction
of the __________________ which carried a booster tank, had a pump capacity of
250 gallons per minute or greater, and carried 21/2 inch and 11/2 inch hoses used
for water supply and firefighting. - ✅✅ Triple-combustion pumper
Which national organization writes codes and standards for fire protection? - ✅✅
National Fire Protection Association (NFPA)
In the early years of U.S. firefighting history, a ______ was used to pull, down a
burning building and prevent the fire from spreading to nearby structures. - ✅✅
Fire hook
The first mechanized fire pumps were generally fueled by: - ✅✅ Coal
In the early 1900's what material did the city of Philadelphia use to develop a
municipal water supply system? - ✅✅ Wood
In the early years of U.S. history, many cities employed watchmen to walk the
streets at night looking for: - ✅✅ fires
Auxiliary braking systems incorporated into apparatus design to supplement the
service brakes include all of the following except: - ✅✅ antilock braking system
(ABS)
Answers Rated to Pass
Which of the following is the correct order of operations for performance testing? -
✅✅ The weight verification test, the braking system test, the parking brake test,
and the road test
Before beginning any performance tests on fire apparatus pumps, all of the
following environmental conditions must be determined and recorded prior to and
immediately after the pump performance testing except: - ✅✅ humidity
When performing a vacuum test, the vacuum inside a pump or suction hose should
not drop in excess of ________________ in __________ minutes. - ✅✅ 10 in; 5
In a pressure control test, the pressure control device should be tested at intervals
of 150 psi, 90 psi, and: - ✅✅ 250 psi
How often should pump tests be performed - ✅✅ Annually
What term refers to a device that allows the bypass of fluids to limit the pressure in
a system? - ✅✅ Relief valve
Which type of test is basically a test of the priming system, specifically the
tightness of the pump, including its valves and fittings. - ✅✅ Vacuum
,When backing a fire apparatus, the driver/ operator should always use a
_________________ if available. - ✅✅ spotter
A 360-degree inspection refers to a(n): - ✅✅ Complete walk- around inspection
of the unit before you go on a response
A warning alarm must activate when pressure in the air system falls below: - ✅✅
60 psi (414 kpa)
What is the normal operating pressure for an air braking system on most fire
apparatus? - ✅✅ 100-120 psi
While driving a fire apparatus around an emergency scene, the driver/ operator
may be forced to maneuver the fire apparatus in a tight area and around obstacles
that are hanging down, such as trees or building signs. NFPA 1002 requires the
driver/ operator to successfully complete a ________________ exercise to
stimulate this challenge. - ✅✅ Diminishing clearance
While responding to an emergency, the driver/ operator may accidentally pass an
intended turn, forcing him or her to turn around. NFPA 1002 requires the driver/
operator to successfully complete a ____________________exercise to simulate
this challenge. - ✅✅ Confined space turnaround
Which of the following delivers operational power to the fire apparatus chassis? -
✅✅ Ignition switch
Which NFPA standard requires the driver/ operator of a fire apparatus NOT move
the apparatus until all persons on the vehicle are seated and secured with seat belts
in approved riding positions? - ✅✅ NFPA 1500
,True or False? If the fire apparatus is equipped with rear mounted camera, it can
take the place of an actual spotter. - ✅✅ False
Which NFPA standard requires that all seats on a fire apparatus be enclosed and
provided with an approved seat belt? - ✅✅ NFPA 1901
If the fire apparatus engine does not start within 30 seconds after the starter has
been engaged release the starter switch and allow the starter motor to cool for
__________________ before attempting to start it again. - ✅✅ 2 minutes
Every fire department should have an SOP that covers fire apparatus backing
procedures who needs to be trained and held accountable for these procedures? -
✅✅ Every member of the Fire Dept.
For most fire departments, the largest number of fire apparatus accidents is related
to: - ✅✅ Backing the apparatus
In accordance with NFPA 1901, a fire apparatus wiht a completely discharged air
system must be able to move within _________________ of start up. - ✅✅ 1
minute
In 1720 what was the piece of equipment to replace the bucket brigade? - ✅✅
Hand Pump
Which NFPA standard required new fire apparatus to be designed so that all
members riding on the fire apparatus would be provided a seated area inside an
enclosed cab? - ✅✅ NFPA 1500
, What was the first gasoline powered fire apparatus to discharge water by using a
large soda acid extinguisher? - ✅✅ Chemical Wagon
The real breakthrough for today's modern fire apparatus came with the introduction
of the __________________ which carried a booster tank, had a pump capacity of
250 gallons per minute or greater, and carried 21/2 inch and 11/2 inch hoses used
for water supply and firefighting. - ✅✅ Triple-combustion pumper
Which national organization writes codes and standards for fire protection? - ✅✅
National Fire Protection Association (NFPA)
In the early years of U.S. firefighting history, a ______ was used to pull, down a
burning building and prevent the fire from spreading to nearby structures. - ✅✅
Fire hook
The first mechanized fire pumps were generally fueled by: - ✅✅ Coal
In the early 1900's what material did the city of Philadelphia use to develop a
municipal water supply system? - ✅✅ Wood
In the early years of U.S. history, many cities employed watchmen to walk the
streets at night looking for: - ✅✅ fires
Auxiliary braking systems incorporated into apparatus design to supplement the
service brakes include all of the following except: - ✅✅ antilock braking system
(ABS)
