TSM 241 Test 2 Questions
with Correct Answers
The ____ port allows a remote administrator to dial into the router through an external
modem. - Answer-auxiliary
When the prompt displayed is the greater than symbol, the router is in ____ EXEC
mode. - Answer-user
If you want to remove the enable secret password, you can type ____ at the global
configuration mode prompt. - Answer-no enable secret
The command ____ displays the current startup configuration file on the router, which is
stored in NVRAM. - Answer-show startup-config
____ in a router typically contains the power-on self-test (POST). - Answer-ROM
If you want to view the contents of the startup-config, you can type ____ at the enable
prompt. - Answer-show startup-config
If you want to see your working or running configuration, type ____ at the enable
prompt. - Answer-show running-config
The command ____ copies the configuration from the TFTP server to the startup
configuration. - Answer-copy tftp startup-config
To manually configure IP on an interface, you must first change to interface
configuration mode. Then, you can use the ____ command to configure an IP address
for the specific interface. - Answer-ip address
You can check the configuration of a specific interface from the enable mode prompt
with the ____ command. - Answer-show interfaces
____ mode is actually the bootstrap program that is built into the firmware of the router.
- Answer-ROM Monitor
with Correct Answers
The ____ port allows a remote administrator to dial into the router through an external
modem. - Answer-auxiliary
When the prompt displayed is the greater than symbol, the router is in ____ EXEC
mode. - Answer-user
If you want to remove the enable secret password, you can type ____ at the global
configuration mode prompt. - Answer-no enable secret
The command ____ displays the current startup configuration file on the router, which is
stored in NVRAM. - Answer-show startup-config
____ in a router typically contains the power-on self-test (POST). - Answer-ROM
If you want to view the contents of the startup-config, you can type ____ at the enable
prompt. - Answer-show startup-config
If you want to see your working or running configuration, type ____ at the enable
prompt. - Answer-show running-config
The command ____ copies the configuration from the TFTP server to the startup
configuration. - Answer-copy tftp startup-config
To manually configure IP on an interface, you must first change to interface
configuration mode. Then, you can use the ____ command to configure an IP address
for the specific interface. - Answer-ip address
You can check the configuration of a specific interface from the enable mode prompt
with the ____ command. - Answer-show interfaces
____ mode is actually the bootstrap program that is built into the firmware of the router.
- Answer-ROM Monitor
