CSWA SIMULATION QUESTIONS AND ANSWERS 2025

CSWA SIMULATION LATEST
ANSWER ALL QUESTIONS IN THIS SECTION



QUESTION 1



what best describes the difference(s) between a fixed and immovable boundary
condition in SOLIDWORKS simulation? - ANSWERS-there is no differences(s)
for solids but it is different for shells and beams



QUESTION 2



can a non-uniform pressure of force be applied on a face using SOLIDWORKS
simulation? - ANSWERS-yes. the non-uniform pressure distribution is defined by
a reference coordinate system and the associated coefficients of a second order
polynomial



QUESTION 3



you are performing an analysis on your model. you select 5 faces, 3 edges and 2
vertices and apply a force of 20lb. what is the total force applied to the model using
SOLIDWORKS simulation? - ANSWERS-200 lb




END OF
PAGE
1

, CSWA SIMULATION LATEST

QUESTION 4



yield strength is typically determined at ____ strain. - ANSWERS-0.2%



QUESTION 5



there are four key assumptions made in linear static analysis:

1. effects of inertia and damping are neglected

2. the response of the system is directly proportional to the applied loads

3. loads are applied slowly and gradually

4. ___________________________________ - ANSWERS-displacements are
very small. the highest stress is in the linear range of the stress-strain curve



QUESTION 6



how many degrees of freedom does a physical structure have? - ANSWERS-six -
three translations and three rotations




END OF
PAGE
2